ohms, pair of 4 ohm svc 12''

Home / the12volt's Install Bay / Car Audio / ohms, pair of 4 ohm svc 12'' (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

gavin_2.6

Member - Posts: 1

Joined: May 07, 2007

Location: United Kingdom

Posted: May 07, 2007 at 11:32 AM / IP Logged

Hi all,

Quick question if you dont mind.

I have just bought a pair on SVC 12 inch subs that are 4 Ohm. I also have an amp that is capable of running 4 Ohms in bridged mode or 2 Ohms in stereo.

I will be getting another one of the same amps next payday so will have 1 amp per sub but for now how can i wire the 2 subs to run from the 1 amp.

All info would be great.

Thanks

Gav

Back to Top

duct tape

Copper - Posts: 125

Joined: May 18, 2006

Location: United States

Posted: May 07, 2007 at 12:20 PM / IP Logged

for now, just run one sub to the left channel, and the other to the right channel. this wont yield the most power from the amp, but will be a safe load for the amp.

when you get your 2nd amp, then bridge one sub on each amp.

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

ohms, pair of 4 ohm svc 12''

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.