the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

My dash and tail lights keep going out


Post ReplyPost New Topic
< Prev Topic Next Topic >
83malibuRida 
Member - Posts: 46
Member spacespace
Joined: January 21, 2005
Location: Georgia
Posted: January 21, 2005 at 9:20 AM / IP Logged  
My 83 chevy malibu is virtually undrivable at night. Ive gone to electronic shops to get estimates and the lowest was $50 an hour. that was just to figure out what was wrong, not to correct the problem.  The fuse keeps blowing and this is a recent reoccuring problem.  I have had the car for three years now and it just started a few months ago but its not a new thing because I contacted the previous owner and he was having the same problem but instead of fixing it he decided to sell it to meMy dash and tail lights  keep going out -- posted image.. The car is equipped with a DEI rattler that the previous owner had installed. if any one knows of any quick test to narrow down what is going on or replacements I can make to fix the problem I would be VERY thankful.
Nick Scott
kenmci 
Copper - Posts: 161
Copper spacespace
Joined: July 15, 2003
Location: United States
Posted: January 23, 2005 at 5:18 PM / IP Logged  
if your tail lights and dash lights (parking lights) are going out then check the parking light wire on the alarm.  If you have an aftermarket deck then check the illumination wires.  It sounds like one of those wires is shorting out causing  your fuse to blow
83malibuRida 
Member - Posts: 46
Member spacespace
Joined: January 21, 2005
Location: Georgia
Posted: January 24, 2005 at 9:40 AM / IP Logged  
THANK YOU!!! Do you have any idea what color are those wires? or where I can get the color codes?
Nick Scott
Mwsounds 
Copper - Posts: 61
Copper spacespace
Joined: January 04, 2005
Location: Alaska, United States
Posted: January 24, 2005 at 10:44 AM / IP Logged  

Nick,

The wire off of the alarm is solid white. This wire should be fused coming out of the alarm brain. If this fuse was bypassed that could be the problem, otherwise it is probably not the alarm. That  fuse would blow if the polarity setting on the alarm was wrong for the car.

Thanks,
Mike Ward
Get it done right the first time!
Mwsounds 
Copper - Posts: 61
Copper spacespace
Joined: January 04, 2005
Location: Alaska, United States
Posted: January 24, 2005 at 10:45 AM / IP Logged  

Nick,

Also, you can check the forums here on the site for the wire colors for your car.

Thanks,
Mike Ward
Get it done right the first time!
83malibuRida 
Member - Posts: 46
Member spacespace
Joined: January 21, 2005
Location: Georgia
Posted: January 26, 2005 at 10:31 AM / IP Logged  

Mike,

"The wire off of the alarm is solid white. This wire should be fused coming out of the alarm brain. If this fuse was bypassed that could be the problem, otherwise it is probably not the alarm. "

First off thanks, the white wire is fused and connected to  the "rear marker light power" wire,  (brown in my car), at the fuse box it has 12v but there is a plug connected to the left side of the box with the wires going to the rear lights and I get nothing(no power) are these constant 12v wires? I had the lights on at the switch.

Nick Scott
overworked 
Copper - Posts: 133
Copper spacespace
Joined: November 09, 2004
Location: Australia
Posted: January 27, 2005 at 6:04 PM / IP Logged  
I had the same sort of drama when I did my first installation of a head unitI didn\t cap the illumination wire when I removed it off of the origianl head unit, pull out the new head unit and and insulate the ends of any wires not connected to anything, if there isn't any use the forums guide of wiring diagrams and trace the ill wire for its entire route and make sure that there i no shorting anywhere...remember to look carefully though it only takes the tiniest nick to cause a short! also check for other accesories that have been added on to th car, if the illumination wire was tapped into thinking it was an earth then this would cause the same problem and cause an accessorie to stop working as well <~~~~speaking from inexperience....whoops! hope I have been of some help! later tater!

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Thursday, April 25, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer