the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

Use voltage drop to trigger relay?


Post ReplyPost New Topic
< Prev Topic Next Topic >
thekorn 
Member - Posts: 1
Member spacespace
Joined: October 02, 2017
Location: Washington, United States
Posted: October 02, 2017 at 2:14 PM / IP Logged Link to Post Post Reply Quote thekorn
I have steering wheel buttons for cruise control on a 2004 Jeep Wrangler. I have swapped in a Chevrolet Gen 3 engine. The Jeep's cruise buttons have a constant 5v running through them. If you push any of the 5 momentary switches the voltage drops accordingly. Is there a way to determine the amount of voltage drop and convert that into a separate 12v signal for each?

If you wish to post a reply to this topic, you must first login.
If you are not already registered, you must first register.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Friday, March 29, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer