Store display material

i can't see an edit button so another point, you can also get some nice venidered mdf, alot easier to cut and looks exactly the same with the venire on it's harder to find though than formica any diy place will have that.

Alright,

Formica can be cut by scoring it a few good times (special scoring knife used, just a plain ole box cutter sucks) then you can just snap it like you would glass, the better method is to use a saw (circular saw or table saw) with a fine tooth blade and set the depth real low so the blade only sticks out a smidgen. If you use the circular saw be sure to set up a guide for straight cuts cause its hard manually with not much blade stickin out.\

Be sure to cut the pieces a little bigger than the actual size, by like an 1/8 of an inch or so.

Now once you have the pieces cut place them on ur hard surface, mdf or what not and check the fit. Dont worry if they stick over a bit, thats what you want. In order to mount the laminate ( i.e. ur formica) use some good contact cement outa the can, give both peices a good spread, even but good. Then after a few minutes when the glue has set you can place ur peices together, you have one chance cause its wicked hard to undo.

Then after the stuff is glued on take a router with a laminate bit (cutting piece with a bearing) and use it cut off the excess laminate, or they make a cheap tool that will cut the excess off, dont recommend it though.

Welp thats bout it, Good Luck.