73 Cutlass dash repair

Home / the12volt's Install Bay / Fiberglass, Fabrication, and Interiors / 73 Cutlass dash repair (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

secureauto

Copper - Posts: 196

Joined: January 02, 2003

Location: California, United States

Posted: January 30, 2005 at 12:10 AM / IP Logged

I'll be installing a deck into a 73 Olds Cutlass, a previous installer cut a din sized hole in the dash where the original 2 knob was. My problem is, there's a half moon shaped hole on the side of the din sized hole, what can you guys suggest to cover it up with?

Bondo, Duramix?

ASE Certified

Back to Top

realitycheck

Silver - Posts: 751

Joined: September 09, 2004

Posted: January 31, 2005 at 7:35 AM / IP Logged

Well Im not completely sure what you're saying but I guess you could use duramix and some abs plastic. I'm not sure what kind of hole your talking about though.

Learning the trade one fiberglass creation at a time!

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

73 Cutlass dash repair

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.