the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

static when touching the gains.


Post ReplyPost New Topic
< Prev Topic Next Topic >
Fosgate3 
Copper - Posts: 328
Copper spaceThis member has made a donation to the12volt.com. Click here for more info.spacespace
Joined: January 29, 2004
Location: Louisiana, United States
Posted: January 19, 2012 at 8:29 PM / IP Logged  
When I adjust the gain on my Kicker DX700, I hear a static sound from the sub and the output of the sub will either decrease or increase significantly with very little movement of the gain. It reminds me of the static and intermittent volume changes with old shaft-mount radios.
Could this possibly be fixed by spraying the gain pot with tuner spray or some sort of electronics cleaner? The amp has seen a little dust over the years so it's entirely possible that the pot is dirty. Just curious if anyone experienced this.
i think a wire's loose somewhere...
i am an idiot 
Platinum - Posts: 13,667
Platinum spaceThis member consistently provides reliable informationspace
Joined: September 21, 2006
Location: Louisiana, United States
Posted: January 19, 2012 at 8:51 PM / IP Logged  
Do not use tuner or contact cleaner.  WD-40 is the way to go.  If the potentiometer is sealed, you may have to remove the control from the circuit board and go to a hardware store and purchase a pipe nipple that the pot will fit into.  Purchase 2 plastic pipe caps as well.  Drill a hole in one of the pipe caps.  Insert the pot into the nipple and put enough WD-40 to cover the pot.  Now take a rubber tipped blow nozzle attached to an air hose and pressurize the aparatus.  This will inject the WD-40 into the sealed pot. 
Fosgate3 
Copper - Posts: 328
Copper spaceThis member has made a donation to the12volt.com. Click here for more info.spacespace
Joined: January 29, 2004
Location: Louisiana, United States
Posted: January 19, 2012 at 8:58 PM / IP Logged  
Ok. thanks man. I'll pull the amp tomorrow and check it out. :)
i think a wire's loose somewhere...
i am an idiot 
Platinum - Posts: 13,667
Platinum spaceThis member consistently provides reliable informationspace
Joined: September 21, 2006
Location: Louisiana, United States
Posted: January 19, 2012 at 9:00 PM / IP Logged  
With the engine running, if you touch the heat sink of the amp, do you hear a humming noise coming through the speakers?  Not engine noise but a 60 cycle hum?
Fosgate3 
Copper - Posts: 328
Copper spaceThis member has made a donation to the12volt.com. Click here for more info.spacespace
Joined: January 29, 2004
Location: Louisiana, United States
Posted: January 19, 2012 at 9:21 PM / IP Logged  
not that i recall. i'll check it in the morning and see. to date though, i dont recall hearing such a noise. and the static is only when i touch the gains. i was wondering why i wasnt having any output on that sub and when i touched the gain, i heard the static and the sub got really loud suddenly, then really quiet without me really turning the gain.
i think a wire's loose somewhere...
i am an idiot 
Platinum - Posts: 13,667
Platinum spaceThis member consistently provides reliable informationspace
Joined: September 21, 2006
Location: Louisiana, United States
Posted: January 19, 2012 at 10:04 PM / IP Logged  
If the hum is present when you touch the amp, it could be an issue with the tiny surface mount fuse inside the amp.  So if it does hum, do not remove the pot.  With the amp turned off, turn the pot from end to end about 20 times.  This action will kind of clean the pot.  If that makes it a little better, the WD will fix your problem.

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Friday, April 19, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer