the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

Amps cutoff, head unit stays on


Post ReplyPost New Topic
< Prev Topic Next Topic >
awd_sr 
Copper - Posts: 84
Copper spacespace
Joined: June 04, 2002
Location: United States
Posted: June 09, 2006 at 11:41 AM / IP Logged  
I have a 2001 Jeep Cherokee. I run 2 8 gauge power cables from the battery back to a distrubution block under the back seat. I then run 8 gauge power cable to each of 3 amps: Jensen KA 4400, MTX Thunder 280, and Alpine MRP-F240 . Also, I feed a relay from the distibution block triggered by the remote lead from my Sony head unit, which feeds all 3 amps as well. Here's my problem, whenever I turn the volume up or play a CD loud, the amps die out, but the head unit stays on. The voltage drops coming from the remote lead fed realy output below 12 Volts as I turn up the volume. I wasn't able to pinpoint the exact voltage the amps die out at because my neighbors are outside, and I dont want to play the music too loud (gotta be a good neighbor) ;)
Will installing a capacitor inline help prevent this from happening? If so, should I place it on the "input" side of my distribution block so all amps and remotes will be covered by it? And how big of a cap should I get?
More details on setup:
Jensen KA 440: 400W Peak into 4 channels
MTX Thunder 280: 280W Peak into 1 channel (bridged)
Alpine MRP-F240: 100W RMS into 2 channels (bridged)
awd_sr 
Copper - Posts: 84
Copper spacespace
Joined: June 04, 2002
Location: United States
Posted: June 09, 2006 at 12:20 PM / IP Logged  
I finally got the search engine working and read a few posts about capacitors on the forum. Since my system is really only about 540W RMS, would I really need to upgrade my alternator? I was hoping that using the capacitor would help when the demand was there for more power, since my system is more "casual", and I dont turn it up really loud for long periods of time. Thanks for the help.
xtremej 
Gold - Posts: 1,440
Gold spaceThis member has made a donation to the12volt.com. Click here for more info.spacespace
Joined: February 24, 2006
Location: United States
Posted: June 09, 2006 at 2:01 PM / IP Logged  
a capacitor is not the answer, it will only further tax your electrical system. Are your lights dimming when you have your stereo truned up? As far as the amps cuttin out try this run 12 volts from your power cable to the remote turn on terminal on the amp. Now turn up the stereo if it doesn't cut out set up like this its your turn on lead. If it still cuts out problem is else where. Make sure you disconnect the remote turn on wire from the stereo to this amp also.
geepherder 
Platinum - Posts: 3,668
Platinum spaceThis member consistently provides reliable informationspace
Joined: October 27, 2003
Posted: June 09, 2006 at 7:34 PM / IP Logged  

If the relay is connected to the distribution block that feeds power to the amps, and the relay is putting out below 12 volts, then there's a good chance the amps are receiving less than 12 amps as well (since the power source is the same).  When you check this voltage, where are you connecting the negative probe on the multimeter to ground- at the amp(s) negative terminal(s)?  This is where you should be testing.  Is this less than 12 volts with the engine running as well?

Check the voltage at the battery terminals while the engine is running and no accessories on (stereo off, etc.).  Are you getting around 13.5 volts or better?  What about when you place a load on the system by turning on lights, stereo, etc.?  If the alternator seems fine, you should check the amp(s) ground as the culprit.  If you're not sure about the alternator, your local parts store should test it free of charge.

My ex once told me I have a perfect face for radio.

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Friday, March 29, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer