2007 nissan sentra, stereo wiring

I have a 2007 nissan sentra and i need the Stereo Wire Colors.

Radio 12v             blue              +       radio harness Radio Ground      (chassis)             Radio Ignition             pink              +       radio harness Radio Illumination      yellow/red       +       radio harness Factory Amp Turn-on      blue/white or pink       +       radio harness Power Antenna      N/A             LF Speaker +/-      purple - GREEN/ YELLOW       +,-      radio harness or amp under rear deck RF Speaker +/-      brown - BROWN / white       +,-      radio harness or amp under rear deck LR Speaker +/-      orange - BLACK/ pink       +,-      radio harness Notes: On vehicles with premium audio systems, the LR speaker wires are YELLOW /GREEN - WHITE/ orange. RR Speaker +/-      gray - gray/red       +,-      radio harness Notes: On vehicles with premium audio systems, the RR speaker wires are RED / black - gray/blue.

Any info on Alarm schematic?

12volts WHITE/ red (40A)   +   ignition harness Starter BLACK/ white   +   ignition harness Ignition BLACK/ red   +   ignition harness Power Lock gray   -   SECU right of column, pin 23 Power Unlock PURPLE / red   -   SECU right of column, pin 35 Lock Motor RED / black   5wi SECU right of column, pin 15 Unlock Motor blue/red   5wi SECU right of column, pin 13 Disarm Defeat WHITE/ red   5wi SECU right of column, pin 14 Parking Lights+ WHITE/ red or RED / blue   +   headlight switch or driver kick Parking Lights- N/A        Hazards ORANGE / black (w/keyless only)   -   SECU right of column, pin 7 Turn Signal(L) GREEN/ black   +   turn signal switch Turn Signal(R) GREEN/ YELLOW   +   turn signal switch Door Trigger see notes   -   SECU right of column Notes: Vehicles with power door locks, the driver door is red in pin 29, and the passenger doors are RED / white in pin 28. Use both wires and diode isolate each. Vehicles without power door locks, the door trigger/dome light is RED / white in the driver kick, harness to rear. Dome Supervision RED / yellow   -   SECU right of column, pin 8 Trunk/Hatch Pin RED / black   -   SECU right of column, pin 38 Hood Pin N/A        Trunk/Hatch Release red   -   trunk release switch Power Sliding Door N/A        Factory Alarm Arm lt. GREEN/ red   -   SECU right of column, pin 41 Factory Alarm Disarm WHITE/ blue   -   SECU right of column, pin 30 Disarm No Unlock see factory alarm disarm        Tachometer NOT GREEN / WHITE or BLACK/ yel   ac   any ignition coil Horn Trigger WHITE/ green   -   horn switch or SECU, pin 19 Memory Seat 1 N/A        Memory Seat 2 N/A        Memory Seat 3 N/A        Interface Module: Category: Immobilizer Bypass Required: Yes Type: Transponder wire4veins

"D"

Precision Autosound - Owner

MECP Master Installer

thanks wire4veins

No it is not ok. Say you are using a 600 watt amp that requires 4 gauge power and ground. Are you going to then go ahead and wire that into a 2 or smaller gauge wire? I think not

I meant 12 gauge instead of 2 on my last post.

Anyone have alarm wiring for a 2007 sentra with I-key. It is different than the one posted. All heavy gauge wires from the ignition switch are solid colors(green,yellow,blue,red,white)