remote start on 2004 tahoe

Home / the12volt's Install Bay / Car Security and Convenience / remote start on 2004 tahoe (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

helmsb

Member - Posts: 8

Joined: December 28, 2007

Posted: December 28, 2007 at 1:15 PM / IP Logged

Just installed a Valet model 562t and a XK01 doorlock & alarm interface. It works fine but when I use the remote start the service engine light comes on and the trans does not shift right. If you use the key it runs fine. Any ideas

Back to Top

usabuilt

Copper - Posts: 161

Joined: September 11, 2007

Location: United States

Posted: December 28, 2007 at 2:52 PM / IP Logged

make sure you have 2nd ign hooked up white wire, and accessory orange wire, also make sure the 2nd ign does not drop out when the engine cranks.

Back to Top

helmsb

Member - Posts: 8

Joined: December 28, 2007

Posted: December 28, 2007 at 4:35 PM / IP Logged

Just cheked wiring looks right. I am going to get meter to chek for drop out. I think there is also a brown acc wire from the switch , does it have to be tied in to the remot start.

Back to Top

helmsb

Member - Posts: 8

Joined: December 28, 2007

Posted: December 28, 2007 at 5:25 PM / IP Logged

this is what I got from switch red=12 volt red-white=12 volt pink is hot with ing then drops to 9.8 volts at start orange is hot in run only white is hot in acc and run but drops to 9.8 at start brown is hot in acc and run only. The relay satellite that these wire go to has another hot wire that it says to use if it is needed , how do you know if it is needed?

Back to Top

saskpuller

Copper - Posts: 144

Joined: November 14, 2006

Location: Canada

Posted: December 29, 2007 at 6:56 AM / IP Logged

The aux relay must be set to igntion and wired to the white wire that is up there beside the brown and orange wires. This is your second igntion and is required to prevent tranny damage among other things.

Back to Top

helmsb

Member - Posts: 8

Joined: December 28, 2007

Posted: December 29, 2007 at 5:19 PM / IP Logged

today added 12 volts to the wire that is to be used if you need extra power to and everything works. I have set everything up but to unlock doors you have to push the unlock button 3 times. The first time you push the relay clicks but does nothing. 2nd time it relocks the doors and the 3rd it unlocks.

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

remote start on 2004 tahoe

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.