code alarm mv 3

Home / the12volt's Install Bay / Car Security and Convenience / code alarm mv 3 (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

519civiconair

Copper - Posts: 50

Joined: October 30, 2007

Location: Ontario, Canada

Posted: January 28, 2008 at 3:55 PM / IP Logged

I have a viper 550 esp and code MV-3 it seems the output of the interior zone isnt long enough to trigger the full alarm anyone ran into this before and or know a solution THNX in advance

F.B.S.S air ride is the only way to roll

Back to Top

datadesign

Member - Posts: 6

Joined: December 29, 2007

Location: Arkansas, United States

Posted: January 30, 2008 at 8:02 PM / IP Logged

Are you sure the green and blue (int full and ext pre) wires are not reversed?

Do you have another sensor connected with the mv-3 to the 550 input port? If so are you using diodes?

DataDesign

Back to Top

datadesign

Member - Posts: 6

Joined: December 29, 2007

Location: Arkansas, United States

Posted: January 31, 2008 at 11:26 AM / IP Logged

Also for got to mention - make surethatyour notin setup/test mode. Make sure that sw1 and sw2 are both off or both on.

DataDesign

Back to Top

datadesign

Member - Posts: 6

Joined: December 29, 2007

Location: Arkansas, United States

Posted: January 31, 2008 at 7:13 PM / IP Logged

Let's try again - this time in english.

Also forgot to mention - make sure that your not in the setup / test mode. Make sure that sw1 and sw2 are both off or both on.

DataDesign

Back to Top

519civiconair

Copper - Posts: 50

Joined: October 30, 2007

Location: Ontario, Canada

Posted: February 11, 2008 at 1:40 AM / IP Logged

Sorry for not getting back to this... my computer went in for upgrading....NEWAYS THNX for the reply... The answer to is another sensor hooked up is YES and are they isolated YES it just seems like its not long enough to trigger the full alarm. I have HUNDREDS of alarms,remote starts and sensors from Diff. manufacturers all of the dual zone motion sensors except the code alarm trigger the full alarm on ALL types of alarms/remote starts when hooked up to a harness made up for two sensors. Any suggestions will be greatly appreciated as I hav a bunch of them and would like to be able to use them... not just as a warn away... although that would atleast help.

F.B.S.S air ride is the only way to roll

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

code alarm mv 3

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.