the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

08 mazda 3 keyless


Post ReplyPost New Topic
< Prev Topic Next Topic >
slim64684 
Member - Posts: 3
Member spacespace
Joined: April 02, 2007
Location: United States
Posted: April 08, 2008 at 9:15 PM / IP Logged  
i have an 08 Mazda 3 with no power locks. I was just going to add actuators but when i got the door off i found that it already had actuators and wiring going to them. I then proceeded to to the the GREEN/ red wire for unlock with a straight negative and I could hear a relay click by the fuse block. I checked the fuses listed for door locks and they were all good. Does anyone know if i can just tie into the yellow/black and WHITE/ black in a 5 wire configuration and the locks will work or do i need to go into each door?
Thanks
Rob
KarTuneMan 
Platinum - Posts: 7,056
Platinum spaceThis member has made a donation to the12volt.com. Click here for more info.spaceThis member consistently provides reliable informationspace
Joined: December 14, 2004
Location: Isle Of Man
Posted: April 08, 2008 at 10:34 PM / IP Logged  

You have a 2008 Mazda without power door locks? Does this car even exist?

This car has a 1 wire lock set up. can be found in the drivers kick.

slim64684 
Member - Posts: 3
Member spacespace
Joined: April 02, 2007
Location: United States
Posted: April 09, 2008 at 10:17 AM / IP Logged  
ya its the base modle. no power anything. but the actuators are there. I tried using the door lock wire and the relay clicked but none of the actuators worked. can i just 5 wire it?
KarTuneMan 
Platinum - Posts: 7,056
Platinum spaceThis member has made a donation to the12volt.com. Click here for more info.spaceThis member consistently provides reliable informationspace
Joined: December 14, 2004
Location: Isle Of Man
Posted: April 09, 2008 at 10:45 AM / IP Logged  

Can you take a peek into the drivers kick to see if the lt.grn/red lock wire is even there?

If the car has actuators, I gotta think that it's wired, just no switches. maybe?

On this wire lock is ground pulse thru a 1K ohm resistor, and unlock is straight ground.

Also look for BLACK/ wht, and a blk/blue, same location these are arm and disarm wires. test with the key in the door.

I would look for these options before 5 wiring every door.

slim64684 
Member - Posts: 3
Member spacespace
Joined: April 02, 2007
Location: United States
Posted: April 10, 2008 at 10:04 AM / IP Logged  
the green and red is there i tried pulsing it with a straight ground to see if it would unlock and all i got was a relay click. then i looked for the black and white and the black and blue and tried to pulse those with a ground and again i got the relay to click but no actuator move ment. I am thinking that the actuators in the doors might just be unpluged and that if i can find where it will be as simple at pluging a connector in and then everything should work. Also i tried testing with the key in the drivers door and got nothing on all 3 wires.
2001eclipse 
Member - Posts: 29
Member spacespace
Joined: July 09, 2007
Location: California, United States
Posted: May 25, 2008 at 9:06 PM / IP Logged  
All of these cars do NOT come with power door locks, Ive installed actuators in 1 for a sidejob a couple months ago. Adding actuators is pretty simple if you have experience installing actuators.
2001eclipse 
Member - Posts: 29
Member spacespace
Joined: July 09, 2007
Location: California, United States
Posted: May 25, 2008 at 9:07 PM / IP Logged  
Oops I meant to say Not all of the cars come with power door locks....

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Thursday, April 25, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer