the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

08 chrysler sebring convertible


Post ReplyPost New Topic
< Prev Topic Next Topic >
ceasar326 
Copper - Posts: 239
Copper spaceThis member has made a donation to the12volt.com. Click here for more info.spacespace
Joined: February 02, 2006
Location: Minnesota, United States
Posted: September 25, 2009 at 1:33 PM / IP Logged  
Need wiring diagram for remote start. thanks. Cesar
chev104275 
Gold - Posts: 1,419
Gold spaceThis member has been recognized as an authority in Mobile Security and Convenience. Click here for more info.spacespace
Joined: November 26, 2007
Location: Massachusetts, United States
Posted: September 25, 2009 at 1:37 PM / IP Logged  
Remote Start       
WIRE COLOR POLARITY LOCATION
Battery RED / (+) IGNITION SWITCH HARNESS
Ignition 1 PINK (+) IGNITION SWITCH HARNESS
Accessory 1 VIOLET/BROWN
   ACCESSORY IS NEGATIVE TRIGGER THRU A 610 OHM RESISTOR.   
Starter 1 YELLOW/VIOLET (+) DRIVER FENDER (NOT FOR REMOTE START)
   NOT FOR REMOTE START,   
Starter 2 VIOLET/BROWN MUX IGNITION SWITCH HARNESS
   USE A 180 OHM RESISTOR FOR STARTER 2, SAME WIRE FOR ACCESSORY,   
Anti-Theft Type DAIMLER SENTRY KEY® VEHICLE IMMOBILIZER
Anti-Theft Descript THE KEY SENDS AN RF SIGNAL TO THE BCM MODULE THROUGH AN ANTENNA LOCATED AROUND THE IGNITION CYLINDER
Key Sense SAME AS SECOND STARTER WIRE (-) IGNITION SWITCH HARNESS
   KEY SENSE IS NEGATIVE TRIGGER THRU A 8500 OHM RESISTOR.
Neutral Safety BLACK/ LIGHT BLUE (-) IN HARNESS TO TRANSMISSION
Tachometer UNCOMMON WIRE AT FUEL INJECTOR
Speed Sense DARK GREEN/ BROWN (AC) AT THE PCM
   PIN 32 ON THE 6 CYLINDER MODELS, IT IS IN THE BLACK/ GREEN PLUG. PIN 89 ON THE 4 CYLINDER MODELS, IT IS IN THE 96 PIN PLUG.
Parking Lights WHITE/ VIOLET (+) DRIVER KICK PANEL HARNESS
Low Crr. Pk Lights N/A
Brake Lights DARK GREEN / WHITE (+) AT SWITCH ABOVE BRAKE PEDAL
Reverse Lights WHITE/ GREEN (+) IN HARNESS IN DRIVERS DOOR SILL
Horn GREEN/ VIOLET (-) SWITCH OR CLUSTER, PIN 10, BLACK 20 PIN PLUG
Doorlocks/Windows       
WIRE COLOR POLARITY LOCATION
Power Unlock GRN/DARK GREEN OR GRN/VIOLET (-) DRIVER KICK PANEL
   PIN #15   
PowerLock SAME AS UNLOCK (-) DRIVER KICK PANE
   MUST USE RELAYS. UNLOCK IS NEGATIVE TRIGGER THRU A 100 OHM RESISTOR. LOCK IS NEGATIVE TRIGGER THRU A 330 OHM RESISTOR
If i Can't Install it    I Don't need it   Joe
ceasar326 
Copper - Posts: 239
Copper spaceThis member has made a donation to the12volt.com. Click here for more info.spacespace
Joined: February 02, 2006
Location: Minnesota, United States
Posted: September 25, 2009 at 3:57 PM / IP Logged  
Thanks for the info. This is for a customer. Is it possible to make the remote start work with out an extra key. i was thinking of hiding the key in the ignition since customer dont whant to pay $240 to make a copy of the key. How can i make thins work with out an extra key and wiring.
flobee4 
Silver - Posts: 585
Silver spacespace
Joined: January 02, 2004
Location: United States
Posted: September 25, 2009 at 4:41 PM / IP Logged  
Yep, there are bypass modules for chrysler that have recently been released that you do not need to give up a key. Here is a link to one of the companies that make these modules. You will need one of their modules listed that is compatable with their CH5 software. You can also view the installation manual there.
Idatalink
ceasar326 
Copper - Posts: 239
Copper spaceThis member has made a donation to the12volt.com. Click here for more info.spacespace
Joined: February 02, 2006
Location: Minnesota, United States
Posted: October 02, 2009 at 12:29 PM / IP Logged  
Do i need to hook up the starter from the remote start brain to the car or will 2nd starter be fine. im using omegas im-532. thanks
flobee4 
Silver - Posts: 585
Silver spacespace
Joined: January 02, 2004
Location: United States
Posted: October 02, 2009 at 11:04 PM / IP Logged  
Yoou will hook up the remote starters start output to the 532's pink starter wire. On this particular car thats is the only place the remote starters start wire will go. Then the 532's Violet/white wire goes to your second starter wire Violet/brown in the car. No resistors required, the 532 takes care of all that for you. Just follow the directions for the 532. Here it is, just incase you need it.
Frank
ceasar326 
Copper - Posts: 239
Copper spaceThis member has made a donation to the12volt.com. Click here for more info.spacespace
Joined: February 02, 2006
Location: Minnesota, United States
Posted: October 02, 2009 at 11:14 PM / IP Logged  
Thanks frank got it working with compustar 5200 remote start only and used Idatalink bypass blade-al and only hooked up ignition, data in, data out, parking lights, 12volt, and ground. Blade-al did the rest.

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Friday, March 29, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer