autopage rs 1000 trigger during rs

Hello all,

I have an Autopage RS-1000 hooked up in a 2006 Escalade EXT and I am not sure if I am missing anything but the alarm goes off (door trigger) right before remote start.  This vehicle has been a PITA for the door triggers so I decided to just use the domelight has the all door trigger.  This is the only trigger I have connected at the moment.  there is no shock sensor or tilt module connected etc.

The unit does not trigger for two days sitting in the garage. I had it rewired a few times tracing down a battery draining issue which was traced to my Idatalink module so I replaced it.  I just remote start it and as soon as it turns the ignition on, which am sure the domelight came on, then the alarm triggers while the vehicle is running and i have to unlock the the doors to disarm.  Take into consideration that the factory alarm is not what went off, the aftermarket alarm did.  The factory alarm disarmed ok. 

I would think the brain would ignore that trigger since its initializing the remote start sequence?  I might not have any option but to unlock upon RS and Relock.  This sucks, any ideas?

I see an option in the programming to ignore the domelight for 45secs with IGN on or off.  I hate to wait 45 sec for my alarm to go off if someone gets into the truck.....(:

Thanks

ok fellows,

I may have found the problem.  I realize that when i lock the doors the domelight comes on for a brief second.  The unit is set to lock on RS and Lock on shudown so I will just set it to lock after RS shutdown and see if that fix the issue.

Thanks