fortin bypass

Hi Guys,

Should the bypass light come on if you connect the +12v, ground, and ground when running only? Or do the TX RX wires etc need to be connected and communicating as well for the light to come on? I am trying to see if I blew mine up by connecting the GWR to a relay that had no diode protection. Thanks a lot for your help!!!

Peter.

OK,

This module was programmed and working before I did these mods, now it doesn't. Do I have to push the button and insert the harness if it was previously programmed?? I connected everything back up and now I get no light. I tried connecting just the +, -, and GWR to the batt just to see if the light would come on and it didn't! Thanks again for your help!

It is a -ALL module, and it is going back in the truck it came out of. I will try pushing the button upon install, but I have removed and installed it several times without doing that. I did try hooking up the three wires direct to the battery, -, +, and GWR and I do not get a light. I thought I tried GWR straight to ground while the harnesses were plugged in but I was also getting power/ ground from my remote start module wich may have also been a problem (I did wring out the +/- from the autostart module, and they did seem fine...).