Hi, thanks for the reply!
Based On the wiring from this forum, there isn't a parking brake wire. Hence I just grounded the wire. However, the error returned from the signal is 6 flashes, which means hood. No idea why it is this way though... There isn't hood sensing in the brain unit.
Yes I cut the jumper wire in the alarm.
Here is a summary of the issues from another email I wrote:
1) Push start not working
After connecting up all the required wires, i stepped on my foot brake, all doors are closed, trunk also closed, and i push the start button for 1 second. However, it keeps returning with signal error: 3 flashes - which according to the manual means that my door isn't closed properly. However, i am 100% certain that it is not an issue with the door sensing as my intruder alert feature works fine (alert sounds if door is opened when system is ARMED).
The manual says that i can by-pass the eBRAKE with i step on the foot brake and hold the start button for 4 seconds. When this happens, i get another error (6 signal flashes) that means the hood is OPEN! But for E7B, there isn't any HOOD sensing! Details in problem #2 below.
2) Remote start not working
Just like the PUSH START, remote start doesn't' work too. I closed all my doors, trunk and hood (no sensing), pushed button II for 2 seconds, but it gives the error signal (3 chirps/signals, then follow by the 6 signals) which means that the HOOD is not closed. However, based on the manual and the inputs of the brain unit, THERE ISNT ANY HOOD SENSING! Is there something wrong with the BRAIN unit? Looking at the manual, it says that E7B should NOT have hood sensing! But how come there is an error code that says HOOD is OPEN? Is the brain unit faulty? Or is it for the wrong model?
3) ACC doesn't turn off when i put the key in
According to the manual, PUSH start button can be installed if i CUT the ACC wire of the car, and connect the key side and the engine side of the ACC wire to CN1 and CN4 respectively. After that, i need to cut my key and turn it to the ACC. However, when i do this, the lights do not turn off even when the push button is set to OFF. I think something is wrong with the brain unit. Please correct if i am wrong …
4) Auto lock/unlock sensing
The AUTO lock and unlock feature works. When i go near the car, about 1 meter away, it will unlock. HOWEVER, when i walk away, it doesn't lock immediately. I have already followed the manual and configure the "TIME TO REARMING" to 0 seconds. But it still takes about 30 seconds before fit locks, after i walk far away.