95 nissan 240sx viper 5701 remote start

Hi All, I trying to wire up the remote start for my 95 Nissan 240sx Manual. As of right now i cant get it to work. Here how its wired up right now. 1 PINK (+) IGNITION 1 INPUT/OUTPUT -> Ignition 1 BLACK/ RED (+) 2 RED / WHITE(30A) FUSED IGNITION 2 / FLEX RELAY INPUT 87 -> SecondStarter BLACK/ WHITE 3 ORANGE ACCESSORY OUTPUT -> Accessory WHITE/ BLUE 4 VIOLET (+) STARTER OUTPUT -> Car side of BLACK / YELLOW (+) 5 GREEN (+) STARTER INPUT -> Key side of BLACK / YELLOW (+) 6 RED (+) FUSED (30A) IGNITION 1 INPUT -> BLACK/ RED 7 PINK/WHITE (+) IGNITION 2 / FLEX RELAY OUTPUT -> STARTER 2 BLACK/ WHITE 8 PINK/BLACK FLEX RELAY INPUT 87A key side (if required) of FLEX RELAY -> NOT USED 9 RED / BLACK FUSED (30A) ACCESSORY/STARTER INPUT -> STARTER BLACK / YELLOW Remote Start Input 1 BLACK/ WHITE (-) NEUTRAL SAFETY SWITCH INPUT -> GREEN / WHITE 2 VIOLET/WHITE TACHOMETER INPUT WIRE -> YELLOW/RED 3 BROWN (+) BRAKE SHUTDOWN WIRE -> RED / GREEN 4 GRAY (-) N/O or N/C HOOD PIN SWITCH INPUT, ZONE 6 -> BLUE Where did i go wrong? Thank You

2 RED / WHITE(30A) FUSED IGNITION 2 / FLEX RELAY INPUT 87 -> SecondStarter BLACK/ WHITE 6 RED (+) FUSED (30A) IGNITION 1 INPUT -> BLACK/ RED 9 RED / BLACK FUSED (30A) ACCESSORY/STARTER INPUT -> STARTER BLACK / YELLOW No they don't they all go to a 12V+ CONSTANT at the ignition loom. WHITE colour. Note the ACC may also be white so TEST. I think your white blue is correct. Right so here goes you will need a 1N4004 diode and a standard automotive relay. RED / Black Red and RED / white to 121V+ feed thick white ignition or fuse box feed same colour. Pink to ign. BLACK/ red. Cut starter 1, BLACK / YELLOW, green to key side and violet to starter side. Cut ACC WHITE/ blue, pink/black to key side, pink/white to other side. **Pink/white to be programmed as second ACC** Thin violet at "relay output plug" via 1N4004 diode, band towards 5701 to relay 85 12V+ Constant, 30 amp fuse to 86 and 87. Relay 30 to BLACK/ white second starter. Please read my signature lines, I agree the install guide is extremely confusing but it's really only meant for pros. Test and confirm every connection before soldering. How did you test to find your neutral safety wire?