viper 5704v on 94 lexus

Does anyone know what wires are required for the whole system install? I can't seem to get the remote start to work.

It's a 1994 Lexus ES300

Ready remote.com or bulldog security.com should have the diagrams Can you list out the connections you've already made.If i Can't Install it    I Don't need it   Joe

H1/1 red constant 12v to WHITE/ red H1/2 black ground H1/3 siren output H1/4 parking light isolation -not used H1/5 parking light output -can't locate the wire inside car... H1/6 not used Door locks are wired up correctly H3/1 pink wired to B/Y ignition wire H3/2 R/W -not used H3/3 Accessory wired to P/B wire H3/4 starter output connected to car side B/W H3/5 starter input connected towards key side B/W H3/6 connected to 12 volt constant H3/7 connected to second ignition B/O H3/8 -not used H3/9 tapped to 12 volt constant Haven't start to wire the second harness yet I did attempt to ground the H2/13 BW wire but nothing still...

PARKING LIGHTS ( + )      GREEN/ BLACK (+)      @ DIMMER SWITCH Sorry I don't have the guide handy for that system what is the H3/2 , H3/8 ? What happens when you try and remote start it ?If i Can't Install it    I Don't need it   Joe

H3/2 = (+) fused 30 a ignition 2 / flex relay input 87 H3/8 = (+) flex relay input 87a key side (if required) of flex relay The remote says error and the module makes about 8 clicks

I believe 8 is manual trans mode or neutral safety ? Did you program the system for auto trans ? Is the override switch plugged in ? If auto trans Is the BLACK/ white neutral safety wire grounded ? If manual trans is it to the e brakeIf i Can't Install it    I Don't need it   Joe

No, the system won't go into program mode, it always goes into valet when i do it. B/W neutral safety wire is grounded and whats the override switch?

Press unlock on the remote before trying to get into programming. There should be a switch that plugs into the main brain inbetween the main 6 pin connector and the door lock connector. How are you trying to get into programming ? Key on key off press and hold programming button until the siren chirps the menu number your looking forIf i Can't Install it    I Don't need it   Joe

chev104275 wrote: I believe 8 is manual trans mode or neutral safety ? Did you program the system for auto trans ? Is the override switch plugged in ? If auto trans Is the BLACK/ white neutral safety wire grounded ? If manual trans is it to the e brake

this should be your problem, just got this "fault code" today, u have a metall switch u plug into alarm, u can choose on/off