compustar cm6000 2 way remote beep

Hello all I am in the process of finishing the install on my RSX with a CM6000-AS and 2 way remote SS kit. I am having one issue which is when I arm the system I get 3 chirps from the siren and horn and the remote beeps a bunch of times and the lights on the remote flash. I have taken this video so as to make it as clear as possible... I have disconnected the hood and trunk wires at the control module of the cm6000 and when i arm the car i get this Everything is closed... Also when I connect the op500 it reads err 1 fail can someone help me please.

Please can anyone help me on this? I need to get this done ASAP

op500 will fail when the system is armed. disarm and then plug in. Plus i don't see the video. its not showingEric

Audiomaxx

528 East Fordham Road

Bronx NY 10458

Compustar Top Gun Dealer Award 2012-2013

I have the system disarmed and have tried to use the op500 with no luck ok here is the link for the video

I have never seen that issue. Reprogram the remote and or reflash the brain on the idatalink website.Eric

Audiomaxx

528 East Fordham Road

Bronx NY 10458

Compustar Top Gun Dealer Award 2012-2013

Ok I will try that in the morning.... I think it might have to do with the door pin switches and the door triggers when I was closing up the car and leaving the garage I closed it all up and it did it again I disarmed it and opened the pass door then armed it and the system chirped 3 times but it didn't show the doors open on the remote....

I believe the problem is that the Compustar is seeing the Hood Pin input signal at Chassis Ground when you press the Lock button. While we are not comparing apples to apples, I get similar results on a FT6200-s install I did today if I raise the hood and hit the Lock button. The first Lock press will flash the Parking Lights three times ( instead of once). The second Lock press will flash the Parking Lights three times and beep the horn three times ( instead of once). Triple check the Compustar to ensure that the Hood Pin input wire is not connected to chassis ground.Soldering is fun!

Okay I have been sick for the last 4 days.... Today i went out to the car and i tapped the drivers door pin switch with a wire and did the same to the pass side, then i put 2 diodes tied both of the anode sides together and connected that to the CN3 Pin 10 RED / white cable at the control module, then the wire from the pass side door to one of the cathode sides of one of the diodes and the drivers side to the other diode, I closed the hood and closed the doors and its still beeping 3 times when I arm and lock