08 Silverado Diesel Duramax Tach Wire

Home / the12volt's Install Bay / Car Security and Convenience / 08 Silverado Diesel Duramax Tach Wire

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

sgarcia1212

Member - Posts: 40

Joined: October 08, 2010

Location: California, United States

Posted: December 07, 2015 at 9:40 PM / IP Logged

Hi all,

I've just installed a python 5206p remote start with DBALL2 D2D on a 2008 Silverado diesel Duramax.

Can someone guide me where I can find the Tach wire on the truck.

Currently I have it set as virtual tach but is very inconsistent.

Thank you in advance.

08 Silverado Diesel Duramax Tach Wire -- posted image.

sgarcia1212

Back to Top

sgarcia1212

Member - Posts: 40

Joined: October 08, 2010

Location: California, United States

Posted: December 07, 2015 at 10:12 PM / IP Logged

I forgot to mentioned that the truck is a 3500 HD.

Thanks.

sgarcia1212

Back to Top

kreg357

Platinum - Posts: 7,783

This member has made a donation to the12volt.com. Click here for more info.

This member has been recognized as an authority in Electrical Theory. Click here for more info.

This member has been recognized as an authority in Mobile Security and Convenience. Click here for more info.

Joined: January 30, 2009

Location: Pennsylvania, United States

Posted: December 08, 2015 at 3:56 AM / IP Logged

Doesn't the DB-ALL2 w/GM6 supply a Tach signal? ( It's shown in the diagram and application guide, but I'm not a DB-ALL2

user, so not sure if it's there on a diesel.) You might try going W2W with the just the Tach signal to see if that works.

Here is a note from ReadyRemote :

On diesel models, use dk. blue/white at the camshaft position sensor, gray 3 pin plug, pin 1 or the Engine Control Module,

black 96 pin plug, pin 56. The camshaft position sensor is on the front of the engine, above the crank pulley. The Engine

Control Module is in the left front of the engine compartment, near the fan shroud.

Soldering is fun!

Back to Top

sgarcia1212

Member - Posts: 40

Joined: October 08, 2010

Location: California, United States

Posted: December 08, 2015 at 4:09 PM / IP Logged

Hi kreg,

I set it to tach mode via bitwriter and learn the tach signal, seems to be pretty consistent so far.

Thanks.

sgarcia1212

Back to Top

If you wish to post a reply to this topic, you must first login.
If you are not already registered, you must first register.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.