07 Camry Remote start install no brake lights

Home / the12volt's Install Bay / Car Security and Convenience / 07 Camry Remote start install no brake lights

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

justinh722

Member - Posts: 1

Joined: March 04, 2007

Location: United States

Posted: December 22, 2015 at 7:20 PM / IP Logged

Car is a 2007 Toyota Camry SE 4 cylinder. I used an Avital 4103LX and an idatalink ADS-TB bypass module. Everything functions as it should, except for the brake lights. I've done quite a few installs and I always solder all of my connections.

I know the brake switch is working because the remote start shuts off when the brake is applied without the key in the ignition. All the bulbs are good. While checking for wires, I did blow the stop fuse. I replaced it but the problem still persists.

The guy needs his car back asap. I'm about to go out and clip the brake input wire to the remote start but I don't think that will make a difference. Anyone have any recommendations?

Back to Top

triniforever

Copper - Posts: 323

Joined: November 12, 2008

Location: New York, United States

Posted: December 22, 2015 at 8:49 PM / IP Logged

Did you check all the fuses in the car? Most likely there is another blown fuse somewhere !

triniforever

Back to Top

If you wish to post a reply to this topic, you must first login.
If you are not already registered, you must first register.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.