04 tundra viper 5706

Home / the12volt's Install Bay / Car Security and Convenience / 04 tundra viper 5706

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

ramon2001

Member - Posts: 45

Joined: August 30, 2006

Location: United States

Posted: February 18, 2016 at 6:14 PM / IP Logged

Installed viper 5706 on 04 Toyota tundra. Everything works great. Lock unlock no problems. Big issue, after activating alarm wait Ike 30 seconds remote start and the anti theft system goes off. Starts honking and lights flash. Vehicle starts and its honking away. turn alarm off, stays on and anti theft also off. What did I miss? How do I deactivate anti theft after remote start? I think that's what's happening. Help will be greatly appreciated. Thanks.

ramon

Back to Top

triniforever

Copper - Posts: 323

Joined: November 12, 2008

Location: New York, United States

Posted: February 18, 2016 at 7:03 PM / IP Logged

Sending a negative to the keysense wire on this vehicle before remote start should disarm the factory alarm or you can program unlock before start and lock after start ? Someone with more experience with this vehicle can give their two cents ? Kreg ?

triniforever

Back to Top

kreg357

Platinum - Posts: 7,783

This member has made a donation to the12volt.com. Click here for more info.

This member has been recognized as an authority in Electrical Theory. Click here for more info.

This member has been recognized as an authority in Mobile Security and Convenience. Click here for more info.

Joined: January 30, 2009

Location: Pennsylvania, United States

Posted: February 18, 2016 at 9:05 PM / IP Logged

Yes, that's the issue. If your Tundra has the Factory Alarm system, a Unlock will unlock the doors and disarm the Factory

Alarm. A Lock will lock the doors and arm the Factory Alarm. So you are good to go there. However, with a remote

start, rather than doing an "Unlock before and a lock after", you can connect the Vipers (-) Status Output wire to the trucks'

Keysense wire. If you are using the Dark Blue (-) Status Output wire for something else ( bypass module ), you can use

the Blue/White 2nd Status Ouput wire for this purpose. Here is the info on the Keysense wire from ReadyRemote :

Keysense YELLOW /GREEN (-) @ ignition key switch, white 2 pin plug, pin 2

04 tundra viper 5706 -- posted image.

Soldering is fun!

Back to Top

ramon2001

Member - Posts: 45

Joined: August 30, 2006

Location: United States

Posted: February 19, 2016 at 11:36 AM / IP Logged

thank you so much for the help. Awesome!!

ramon

Back to Top

If you wish to post a reply to this topic, you must first login.
If you are not already registered, you must first register.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.