2013 Ford Edge V6 standard key

Working with a Python 5706p and Fortin EVO-ALL DEI's install wires have changed since I last used one. The Fortin install diagram is pretty self explanatory but trying to match up the wires Fortin is asking for to the DEI 10-pin heavy harness isn't straight forward. Fortin is looking for: Start Ign2 Ign1 Acc 12V Ground DEI 10-pin harness: RED / Black - Fused 12V Accessory/Starter Input Pink/Black - Flex Relay Input 87a keyside (if req'd) of Flex Relay Pink/White - Ign2 / Flex Relay Output Red - 12V Ign 1 input Green - Starter Input (Key side) Violet - Starter output (car side) Orange - Accessory output RED / White - Fused 12v Ign 2 / Flex relay input 87 Pink - Igntion 1 input/output I'm not use to the flex relay wiring that DEI has going on now. Could someone possibly help in directing me to which wires would tie together between the DEI and car (fortin diagram) unit? Attaching an image of the actual diagram from Fortin.

Going off the diagram I'd assume these connections: DEI --> Car Pink/White --> WHITE/ Orange Red --> GREEN/ Red Pink --> Blue/White Orange --> PURPLE / Green Violet --> Blue/White -Cut (car side) Green --> Blue/White -Cut (key side) RED / Black ?? Pink/Black ?? RED / White ??By the way, it was brought to my attention, on your abbreviation for circuit you use "CKT". There is not "K" in circuit. Should this possibly be CCT? - R. Robson

hahahahahahaha

This might help: https://www.the12volt.com/installbay/forum_posts.asp?tid=132562&tpn=1When all else fails, Read the Instructions

Support the12volt.com Make a Donation

That's a great writeup! I found my issue. RED / Black needs to be connected to 12V as to push 12V to the starter during engage. Thanks for the help!By the way, it was brought to my attention, on your abbreviation for circuit you use "CKT". There is not "K" in circuit. Should this possibly be CCT? - R. Robson

hahahahahahaha