DB3 in Range Extender Ready Mode RXT

Home / the12volt's Install Bay / Car Security and Convenience / DB3 in Range Extender Ready Mode RXT

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

friedwires

Member - Posts: 1

Joined: January 08, 2021

Posted: January 08, 2021 at 2:46 PM / IP Logged

Hi All,

I'm looking for some help or knowledge on the directech DB3 bypass module in RXT mode

Installing in a 2011 Explorer that already has factory remote start, I just want to add a cell phone app option as the ford remote access is no longer supported.

I'm following this guide https://directechs.blob.core.windows.net/ddt/403-FORD3-4.08-RXT_2011-Ford-Explorer-(Smart-Key)_IG_EN_20200116.pdf

My question is if the module was flashed with 403.FORD3 4.08 RXT and options/features setup correctly (smartstart enabled) will I need to remove the bypass again to program the key2go programming or will it work after its installed. The module is being shipped flashed with the correct firmware and options because I dont have access to directechs f'ing website.

I'm not familiar with DB3 or any directech bypass' but its one of my only options found for RXT because I already have factory remote start

Back to Top

If you wish to post a reply to this topic, you must first login.
If you are not already registered, you must first register.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.