Priority locks 99 Blazer

Home / the12volt's Install Bay / Car Security and Convenience / Priority locks 99 Blazer (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

taijiguy

Member - Posts: 8

Joined: December 18, 2003

Location: United States

Posted: January 17, 2004 at 6:13 PM / IP Logged

I've searched the forum, and if this question is posted someplace, I can't find it...sorry if it's a repeat.

Is it possible to retain the factory priority lock operation with an aftermarket security/remote start system? The system I have (Auto Page 850) supports the function, but I can't find info on the wiring terminations. Also, I can't seem to locate the factory alarm disable wire either. Anyone help me out with this? 99 Blazer w/ factory keyless entry and security.

Thanks,

~Taiji

Back to Top

bmf1000d

Silver - Posts: 345

Joined: September 30, 2003

Location: United States

Posted: January 17, 2004 at 6:57 PM / IP Logged

The disarm wire is in the drivers kick panel i believe its light green. As for the door locks if you have a alarm installation manual its usually has the wiring in the back for driver priority if not i can send ya one.

"Big" Mike

Double Take

Fremont, Ne

remember to check all your wires with a dmm not a test light!!

i take no responsibilty whatsoever for the vailidty of the info nor consequences thereof

Back to Top

taijiguy

Member - Posts: 8

Joined: December 18, 2003

Location: United States

Posted: January 20, 2004 at 11:34 AM / IP Logged

Yeah, there are a couple of light green wires coming from the door, but they seem to be associated with the windows. I'm guessing it should show (-) (neg) when unlocked with the remote? The install manual only provided a schematic for making up a driver side priority lock setup when not already installed. I'm hoping to make use of the existing setup, but can't find the necessary data on making the terminations. Anything you can provied would be great.

Thanks

~Taiji

Back to Top

sparkie

Platinum - Posts: 2,061

Joined: November 06, 2003

Location: Canada

Posted: January 20, 2004 at 5:28 PM / IP Logged

The disarm wire can be found in the purple plug of the BCM. The BCM is located under the center of the dash ahead of the floor console. You will need to drop the underdash black panels to access it. You can't use the factory's door unlock priority system as it is built into the BCM/keyless entry module. You must wire in your own relay to isolate the driver's door lock motor wires.

sparky

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Priority locks 99 Blazer

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.