03 Chevy Silverado Parking Light Wire

Home / the12volt's Install Bay / Car Security and Convenience / 03 Chevy Silverado Parking Light Wire (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

tbird2340

Copper - Posts: 363

Joined: October 03, 2003

Location: Ohio, United States

Posted: March 05, 2005 at 10:12 AM / IP Logged

I'm doing a remote start on an 03 Chevy Silverado and got a question.. The parking light wire is gray/black at the swtich. I go to the switch and find 2 gray/black wires. What should the correct wire test at?

Thanks

Back to Top

tbird2340

Copper - Posts: 363

Joined: October 03, 2003

Location: Ohio, United States

Posted: March 05, 2005 at 10:14 AM / IP Logged

Nevermind.. Found it at the brown plug in the bcm..

Back to Top

gcote

Member - Posts: 6

Joined: March 04, 2005

Location: United States

Posted: March 05, 2005 at 10:15 AM / IP Logged

dont use the wire at the switch. use the gray/black at the pcm under the driver side dash this wire is neg. trigger

turn us on

Back to Top

tbird2340

Copper - Posts: 363

Joined: October 03, 2003

Location: Ohio, United States

Posted: March 05, 2005 at 12:21 PM / IP Logged

I've finished up the install on the Silverado and just have a few questions..

When I hit unlock the parking lights blink twice and the daytime running lights / back lights come on for 25 seconds then go off.

When I hit lock the parking lights don't blink at all (which they usually blink once).

When I remote start it the parking lights come on as they should. When I stop the vehicle (via the remote) the lights go off and the horn honks once.

Does all this sound normal?

Also, I don't know if this is a security feature or something but when I remote started it the first time and then stopped it via the remote both doors were open.. A few minutes passed and the horn started honking. I don't know if this was because both the doors were open and it was sorta like a reminder to close them or what.

I locked the doors via the keyfob, waited five-ten minutes and it started successfully with no honk. I just want to make sure all this sounds right.

Thanks

Also, the parking light wire tests 12v postive with the lights OFF and 0V with the lights on??

Back to Top

JWorm

Platinum - Posts: 2,208

Joined: December 11, 2002

Location: New Hampshire, United States

Posted: March 05, 2005 at 6:11 PM / IP Logged

Is the parking light output from your remote start putting out a (-) or (+) signal? It should be (-).

Did you use a databus doorlock interface? If so, which model? If you didn't, did you connect to the factory alarm disarm wire in the drivers door?

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

03 Chevy Silverado Parking Light Wire

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.