2003 Tacoma Power Windows

I have an Aux output on my alarm that I am trying to use to roll my windows up, I dont care about them going down.  The output is negative, but I will use a relay for a 12vdc output if necessary.  I took the door apart and looked at the switch.  Seems pretty easy.  There are 5 pins....I tested for power...1 of them blue/red, was 12 volts.  The others read no power.  I shot for power on the other 4 wires and 12 volts is read on one of these wires with the drivers window going up, 12 volts on a different wire with the passengers window up and so on.  So all 4 of these wires read 12 volts at some point depending on which window is going in which direction.  I don't know a hell of a lot of about this stuff but I figured it'd be pretty simple.  I found the two wires that read 12 volts when each window was going up, it was blue / YELLOW and RED / black I think.  So without pressing the buttons manually, I took a jumper wire and touched the wire that was constant 12 volts, to the blue / YELLOW and RED / black, one at a time.  Nothing happens???  What am I doing wrong?  I removed the switch and between the blue/red (12 volts) and blue / YELLOW read continuity.  Between the blue/red (12volts) and the RED / black red like 200 ohms.  No I confused myself.  I might give up on the whole idea of this.  I was hoping to have the relay send out 12 volts to the RED / black and blue / YELLOW, with diodes after the split.  I figured with 12 volts on each of these wires both windows would roll up until I released the Aux button.  Thanks for any help.suggestions.

matt

This is a Reversal Rest at Ground install...