Omega Max E

Im having problems with my alarm I installed the max e on a 97 crown victoria the problem that im having is the alarm keeps going off by its self....sometimes it doesn't....I unpluged the sensor and it still went off after seating for a while.... Is there anything else that could be triggering the alarm ?

How's the grounding on the alarm ? Check the grounding points. Use a different ground with a star washer so it bites sheet metal and makes good contact.. Check your dome supervision wire. If it is the same wire as the door trigger, it might interfere with the alarm and cause false positives. Put a relay and isolate the dome supervision wire and install a diode on the door trigger. These are suggestions. Someone who worked on this car might have more to contribute..Unfortunately, I have not worked on it..

How's the grounding on the alarm ? Check the grounding points. Use a different ground with a star washer so it bites sheet metal and makes good contact.. Check your dome supervision wire. If it is the same wire as the door trigger, it might interfere with the alarm and cause false positives. Put a relay and isolate the dome supervision wire and install a diode on the door trigger. These are suggestions. Someone who worked on this car might have more to contribute..Unfortunately, I have not worked on it..

I had sliced the ground into the ground in the electrical harness....so I guess I'll try to hook it to a ground spot. Thanx for the help...I'll let yall know if it worked

well I grounded it probably and it still went off

check your hood pin, and double check for your door triggers as well, i installed a k9 classic, same thing with the exeption of the rs, it turned out to be a bad brain though.gcorrea

I used the smart trigger where u connect the trigger to the door pin switch which is hooked to the domelight...but for some reason the dome light supervision only works for a while then I have to push the light knob for the dome for it to come back on when I hit the unlock but... I have the + hooked to the fuse panel...What other place could I put this wire

Well now I have different issues when I used the smart trigger now my drivers door isn't being detected but the domelight works with the supervision and one more thing now when I try to remote start the alarm goes off for a sec and the car doesn't do anything...and when I lock it it chirps more than twice and when i press unlock it chirps 3 times whats the problem please help

the 3 chirps are telling you your alarm was triggered. no sensor plugged in and still goes off might be a pin switch grounding. i woul suggest starting from scratch and rewire you alarm. wher did you get the omega at?gcorrea