CT-3200 on a 1985 Toyota Pickup

Hello, I installed a Prostart CT-3200 on my 1985 Toyota Pickup. Programmed the remote and tach. But when I press the start button, it cranks for about 8 secs then stops then the park lights flash two times. I can't seem to find any thing about diagnostic flashes on these units. Please help and thanks in advance. DaveDataDave21

It sounds like the tach signal isn't correct. The unit is designed to engage the starter for 8 sec until it receives the correct signal. Use a volt meter set on an A/C scale to test from a good ground to the purple tach wire. You should get a reading between 1 and 9 volts that varies with RPM. Make sure the ground for the remote starter is into the vehicle chassis and not just a piece of metal. Recheck the the main ignition wiring connections. You may have reversed the ignition and starter wires by accident.sparky

Thanks Sparky, I'll try that tomorrow. And Re:Post results. DaveDataDave21

if what sparky said doesnt work try re setting the module.i had the same problem in an older cavalier. i reset the module and it worked after that.the customer hasnt been back since .

Hi All, Problem Solved, turned out to be the Second Ignition Wire, I connected it to the BLACK/ Red Wire at the ignition harness, should have been BROWN / White. Thanks for your help. DaveDataDave21