DEI 530T in a 1997 Mazda 626

Hey I installed the DEI 530T in a 1997 Mazda 626. With the Aux channel the windows vent and then a second later they roll down all the way. How do stop that? I can't get the to roll up at all. I'm using the lock wire with a relay to boost the signal and I can't even get it to move. It wont even move if I ground the wire. I've tried three different modules and the same problem. Is it something wrong with the wiring? the drivers switch works all the windows and the front two have one touch now.

I can't seem to figure this out. Been at it for two days and I'm ready to pull it out. Any help will be greatly appreciated. 

Window goes all the way down instead of venting is because the RED / white of the 530 sees a latched signal rather than a simple trigger whose duration matches the press of a button on the TX or maybe it might be connected to one of the gray wires of the 530 as well. Disconnect gray wire from RED / white.

As for the motor wires, be sure that you connected your wires for the driver's door directly to the motor wires in the driver's door for that window only. They are GREEN/ blue and RED / blue.

All other windows are in driver's kick :