trouble programming gmsl2 module

installing a viper 5900 with a gmsl2 bypass module in a 03 envoy. have everything hooked up and i cant get the module to program. the led never blinks when i hold the button and turn the ignition. i tried unpluging the module completely and remote starting the vehicle with the keys in the ignition, the vehicle will inject fuel but wont crank. ive got the tach wire hooked up to the pcm white wire under the hood.  any suggestions would be appreciated. im stumped.

to program, hold programming button (black) plug in the 4 pin harness (black, red, blue, white) then connect the other harness. when the light is solid and lit, let go of programming button. Put key in ignition, the light should rapidly flash 10 times.(about 2 seconds, let it sit for 10 then turn off)  Double check ur wires also.

also when u say u removed ur bypass module, u cant start with the key or is it u cant remote start with they key in the ignition?

the light wont rapidly flash, it just stays solid.

i can definately start it with the key, but i cant remote start it. 

my gmsl2 is version 1.9

here's how my wires are hooked up.

Viper 5900

Relay satellite harness

Purple starter…………………...yellow starter wire in vehicle

Green (anti grind)………………didn’t use

Red (2) + 12v…………………...red 12v in vehicle

Orange accessory……………….orange accessory in vehicle

Pink ignition…………………….pink ignition in vehicle

Pink/white 2^nd ignition………….white 2^nd ignition in vehicle

RED / white (+) 12v input………...red 12v in vehicle

Primary harness (H1)

red 12v……………….…12v power in

brown siren output………siren

black ground…………….ground

green door trigger input (-)…gray/black wire in drivers dome light

Remote start harness (H3)

Neutral safety switch……... to the toggle override switch

Tach input……………..….. to the white wire coming out of the blue pcm harness

Brake shutdown……………hooked to (+) white wire while brakes were applied

Hoodpin switch…………….hoodpin switch under the hood

Blue/white………………….to gmsl2 blue wire (-) while running

GMSL2

Red (+12v)……….to 12v on viper harness

Black (ground)…...to ground on viper harness

Blue (datalink)…..didnt use

White (datalink)….didnt use

Light Blue (lock)…...............didnt use

White (Unlock Driver 1).........didnt use

Pink (ignition)………………...to pink ignition under steering wheel

Blue(- while running)…………to blue/white h3/5

Purple(data obd2)….……..…..to purple obd2 under dash

Orange(door trigger)…….……to green door trigger wire in H1 harness

Lt Blue/Black(trunk)…………didn’t use

WHITE/ Black(unlock driver2)….didnt use

Pink/black(parking light)………didn’t use

well, the remote start will activate, but the starter never engages. i checked for voltage on the purple starter wire and i did find voltage after the remote start becomes active, so there is voltage going through the starter wire. im still stumped.