problems command start, 92 wrangler

Hey Guy maybe you can help me.

I am trying to install a command start PRO START CT-3260 on Jeep Wrangler 1992. It is a manual transmission, no power door/locks/windows/dome light.

I wired up everything except for green wire on the 6 pin plug. The green wire says - ((+) 5th Relay output (30 A) This high-current output can be used to power a second Ignition, Accessories or Crank wire.)

On the 5 pin plug I have everything wired up as per https://www.the12volt.com/installbay/alarmdetail/1233.html . I have Purple wire for the tach input going to the coil and hooked up to Yellow/Black again as per instructions.

Then I have 12 Pin Harness - on that one i have only parking brake wire installed. Not sure if there is anything else to be hooked up on that harness

Basically i can program the remote and i get feedback from it, I also I can go Into a Ready mode, I can start the car with the key, then pull the key out and it will stay running, then when i press 2nd button, engine will shut off. But i cannot start the car with the remote. What did I miss? I do not think car has any security to bypass, and the car starts without pressing clutch. There are #9 and #10 wires on 12 pin harness and I am not sure if they have to be connected, and where should they be connected.

Please Help.

Thanks

Dan

I believe you need a door pin input to the R/S.

If it were an astrostart you were installing....I would know for sure this is the problem.

A Compustar guy will chime in here Im sure.

hey guys, i thought i posted this but maybe i forgot to, but here are instructions to the pro start CT-3260

http://www.engines911.com/asdocs/CT-3260_ig_en_h370s380v155_040922.pdf

Thanks.

here's the thing

there is no door pin on the vehicle at all.

also right now as it stands I am bypassing my parking brake wire, I just ground it out to bypass. I cannot locate the wire for the brake. I just didn't see that wire, any idea where i should hook it up? the cheat sheet says its black with yellow line. But i did not see any black wires with yellow lines. I've seen some yellow with black line, and I tested it, but it wasn't it.

thanks