DIRECTWIRE™ WIRING INFORMATION - KIA / RIO / 2005 / Remote Start
[PRINT THIS PAGE]
12volts blk/blue (30A), grn/red (30A) + ignition harness
Starter blue + ignition harness
Second Starter N/A
Ignition blue/red + ignition harness
Second Ignition blue/black + ignition harness
Third Ignition N/A
Accessory RED / blue + ignition harness
Second Accessory N/A
Keysense blue + ignition harness
Power Lock red - relay high in driver kick
Power Unlock yellow - relay high in driver kick
Lock Motor blue 5wi relay high in driver kick
Unlock Motor green 5wi relay high in driver kick
Parking Lights+ RED / green (L), blue/black (R) + driver kick, harness to rear
Parking Lights- GREEN/ blue - headlight switch or ETWIS
Hazards same as turn signal wires
Turn Signal(L) GREEN/ YELLOW + turn signal switch
Turn Signal(R) GREEN / WHITE + turn signal switch
Reverse Light blue/black + driver kick, harness to rear
Door Trigger GREEN/ red - ETWIS high in driver kick
Dome Supervision white - ETWIS high in driver kick
Trunk/Hatch Pin lt. GREEN/ red - ETWIS high in driver kick
Hood Pin lt. GREEN/ YELLOW - ETWIS high in driver kick
Trunk/Hatch Release N/A
Power Sliding Door N/A
Factory Alarm Arm factory remote only
Factory Alarm Disarm factory remote only
Disarm No Unlock
Tachometer BROWN / red ac ECM or diagnostic plug
Notes: The ECM is in the driver kick panel. The tach wire is in pin 31 in the 52 pin plug.
Can also find the tach wire in the diagnostic plug behind the driver side headlight.
Wait to start N/A
Brake Wire RED / black + brake pedal switch
Parking Brake blue/white to blue/black - driver kick, harness to rear
Horn Trigger lt. GREEN/ red - horn switch
Memory Seat 1 N/A
Memory Seat 2 N/A
Memory Seat 3 N/A
Interface Module: Category:
Immobilizer Bypass Required:
No Type:
N/A
Part #: N/A
Notes:
warning
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.