wiring info needed, ford focus

hi all I have a Ford focus which is stripped out and use for rally only, has a different engine, custom car loom have remade the whole loom ( cut out the bits I don't need etc) but would like some information on the following: Push Start: Use the key for steering lock and ignition then a button to start the car and same button to stop it again? Warning light: Is there any away I can make a warning light to come on when the fuel pump has a low power? Many thanks

Push start ground (earth) to button then to relay 85 Ign to relay 86 Original colour GREEN/ YELLOW 30amp fused 12v+ constant to 87 30 to starter wire original colour grey/black Fuel pump will either be 12v+ or nothing. Fit a voltmeter.

howie ll wrote: Push start ground (earth) to button then to relay 85 Ign to relay 86 Original colour GREEN/ YELLOW 30amp fused 12v+ constant to 87 30 to starter wire original colour grey/black Fuel pump will either be 12v+ or nothing. Fit a voltmeter.

Will this start the car then stop it if I push again??

No, you need to contact Kevin Pierson at KP Technologies, he makes modules to achieve this. Go to one of his posts and click on the "www." section at the base of the post.

Hi all does any one have a wiring diagram for the big plugs in the passenger foot well ( comes from main fuse board ) have lots of wires and the 2nd plug has about 4/5? and the dirgram for the headlight system many thanks