the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

Clifford Solaris Alarm Wiring, 2004 Saturn Ion


Post ReplyPost New Topic
< Prev Topic Next Topic >
austinhanby 
Member - Posts: 1
Member spacespace
Joined: May 25, 2020
Location: Washington, United States
Posted: May 25, 2020 at 12:46 PM / IP Logged Link to Post Post Reply Quote austinhanby
does anyone happen to have a diagram for this alarm, its a clifford solaris, it does not work correctly and was installed poorly. its causing a ton of electrical problems, for example he cant roll his windows down, i can go at it blind no problem but always welcome a good schematic. thanks guys
The definition of insanity is to repeat the same process and expect a different result....   Take a step back and figure out another way, you got this!
wirewise 
Moderator - Posts: 489
Moderator spaceThis member has made a donation to the12volt.com. Click here for more info.spaceThis member consistently provides reliable informationspace
Joined: March 07, 2002
Location: California, United States
Posted: May 25, 2020 at 12:51 PM / IP Logged Link to Post Post Reply Quote wirewise
https://www.the12volt.com/installbay/downloads.asp?srch=all&term=Solaris
~wirewise~ Verify all wiring with your meter before making any connections!
wirewise 
Moderator - Posts: 489
Moderator spaceThis member has made a donation to the12volt.com. Click here for more info.spaceThis member consistently provides reliable informationspace
Joined: March 07, 2002
Location: California, United States
Posted: May 25, 2020 at 12:52 PM / IP Logged Link to Post Post Reply Quote wirewise
ION     2003-2007
KEY     T-HARNESS     IMMOBILIZER
N/A     N/A     SATURN'S MULTIPLEX IGNITION/TRANSPONDER SYSTEM, See NOTE #4
PART     COLOR     LOCATION     DIAGRAM
12 VOLT CONSTANT     RED (+)     @ BCM, C1 PIN 37 and 34, See NOTE #1      
STARTER     SEE NOTE #4           
STARTER 2     N/A           
IGNITION 1     DARK BLUE (+)     IGNITION SWITCH HARNESS      
IGNITION 2     N/A           
IGNITION 3     N/A           
ACCESSORY/HEATER BLOWER 1     BROWN (+)     IGNITION SWITCH HARNESS      
ACCESSORY/HEATER BLOWER 2     N/A           
KEYSENSE     N/A           
PARKING LIGHTS ( - )     N/A           
PARKING LIGHTS ( + )     BROWN (+)     @ HEADLIGHT SWITCH      
POWER LOCK     WHITE (1-Wire System) See NOTE #2     @ BCM C3, PIN 33
POWER UNLOCK     Same wire
LOCK MOTOR WIRE     GRAY (5-WIRE TYPE)     @ BCM, C3, Pin 51, See NOTE #1      
DOOR TRIGGER     SEE NOTE #3     @ BCM, See NOTE #1
DOMELIGHT SUPERVISION     WHITE (-)     @ BCM C3, IN PIN 11, See NOTE #1      
TRUNK RELEASE     BLACK/WHITE (+)     @ BCM C3, IN PIN 1, See NOTE #1      
SLIDING POWER DOOR     N/A           
HORN     BLACK (-)     @ STEERING COLUMN HARNESS      
TACH     WHITE or ORANGE (AC)     IN PIN B or G @ MODULE, TOP LEFT OF ENGINE      
WAIT TO START LIGHT     N/A           
BRAKE     LIGHT BLUE (+)     @ SWITCH ABOVE BRAKE PEDAL      
FACTORY ALARM DISARM     N/A           
ANTI-THEFT     SATURN'S MULTIPLEX IGNITION/TRANSPONDER SYSTEM, See NOTE #4           
NOTES
NOTE #1: THE BCM (Body Control Module) IS PART OF THE FUSE/RELAY BOX IN THE LOWER CENTER OF THE DASH,JUST BELOW THE HVAC CONTROL ASSEMBLY.IT HAS THE FOLLOWING CONNECTORS:C1-37 PIN BLACK PLUG,C2-38 PIN GRAY PLUG,C3-56 PIN BLACK PLUG,C4-56 PIN GRAY PLUG,AND C5-6 PIN GRAY PLUG.
NOTE #2 LOCK IS A STRAIGHT (-) NEGATIVE TRIGGER. UNLOCK IS A NEGATIVE THRU 1.5K OHM RESISTOR, IF THE UNIT DOES NOT HAVE ON BOARD DOOR LOCK RELAYS, EXTRA RELAYS PART #775,WILL BE REQUIRED.
NOTE #3 THE DRIVERS DOOR TRIGGER IS LIGHT GREEN/BLACK (-) IN PIN 45 AND THE PASSENGER DOOR(S) IS LIGHT BLUE (-) IN PIN 44. WHEN CONNECTING TO AN ALARM SYSTEM USE BOTH DOOR TRIGGER WIRES AND DIODE ISOLATE.
NOTE #4: THIS VEHICLE REQUIRES AN INTERFACE BYPASS MODULE TO REMOTE START, PART # DBALL2 or XK09, Part # 779, ignition delay circuit is needed when installing an RS82, RS1100, or RS1200 and a DBALL2 or XK09 interface in a GM vehicle that has no starter/ crank wire coming from the ignition switch.
~wirewise~ Verify all wiring with your meter before making any connections!

If you wish to post a reply to this topic, you must first login.
If you are not already registered, you must first register.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Friday, April 19, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer