the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

2011 Toyota Sequoia, Integrated Brake Controller Wiring Harness


Post ReplyPost New Topic
< Prev Topic Next Topic >
erkme73 
Member - Posts: 16
Member spacespace
Joined: December 30, 2007
Location: Florida, United States
Posted: September 13, 2021 at 8:22 PM / IP Logged Link to Post Post Reply Quote erkme73
I have an 07 Tundra and 11 Sequoia. The Tundra has a functioning brake controller (Tekonsha P3) using their adapter cable. Works fine. A new P3 works find in Tundra but not in Sequoia. I verified the two 30A fuses under hood are good. The wire colors at the factory harness are identical between both vehicles. However, on the Tundra, the 12V+ to ground is on the thick black wire. On the Sequoia, the black wire has no voltage and instead the thin green wire has 12V+ to ground.
I'm befuddled.

If you wish to post a reply to this topic, you must first login.
If you are not already registered, you must first register.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Friday, March 29, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer