1997 gmc jimmy

Home / the12volt's Install Bay / Vehicle Wiring Information & File Requests / 1997 gmc jimmy (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

galantin

Member - Posts: 12

Joined: November 29, 2004

Location: United States

Posted: September 06, 2005 at 6:37 PM / IP Logged

need remote start/alarm wiring colors/locations, thanks

Back to Top

chungo

Copper - Posts: 135

Joined: December 31, 2003

Location: United States

Posted: September 06, 2005 at 7:16 PM / IP Logged

12volts	red	+	ignition harness
Starter	purple or yellow	+	ignition harness
Second Starter
Ignition	pink	+	ignition harness
Second Ignition	white or pink/white	+	ignition harness
Third Ignition
Accessory	orange	+	ignition harness
Second Accessory
Keysense
Power Lock	lt. blue	+	either kick panel
Notes: Also found at the TRW keyless entry module mounted to the under dash panel on drivers side. With the module unplugged, the drivers door lock will no longer function.
Power Unlock	white	+	either kick panel
Notes: Also found at the TRW keyless entry module mounted to the under dash panel on drivers side. With the module unplugged, the drivers door lock will no longer function.
Lock Motor	gray		drivers kick panel
Unlock Motor	tan		drivers kick panel
Parking Lights+	brown		switch or rear harness
Parking Lights-
Hazards
Turn Signal(L)
Turn Signal(R)
Reverse Light
Door Trigger	white	-	keyless module
Notes: Also found at the TRW keyless entry module mounted to the under dash panel on drivers side. With the module unplugged, the drivers door lock will no longer function. This wire cathes all doors, but reads the delay. To keep the alarm from reading the delay, place a diode in-line on the white door trigger wire with the anode towards the keyless module. Attach your door trigger wire to the cathode side of the diode. On non-keyless models the is a module with 5 wires located where the keyless normally resides. The white wire there catches only the front two doors. To catch the rear doors use the white wire at the drivers side rear pin switch.
Dome Supervision	use door trigger
Trunk/Hatch Pin	tied in with doors
Hood Pin
Trunk/Hatch Release	BLACK/ white	+	switch or keyless
Notes: Also found at the TRW keyless entry module mounted to the under dash panel on drivers side. With the module unplugged, the drivers door lock will no longer function.
Power Sliding Door
Factory Alarm Arm
Factory Alarm Disarm
Disarm No Unlock
Tachometer	white	AC	ECM
Notes: The ECM is located on the passenger inner fender well. Located the white wire in a black plug labeled white.
Wait to start
Brake Wire	white	+	at brake pedal switch
Parking Brake
Horn Trigger	black	-	steering column
Memory Seat 1
Memory Seat 2
Memory Seat 3

Interface Module:	Category: Immobilizer Bypass	Required: No	Type: N/A
Part #: N/A
Notes:

Back to Top

galantin

Member - Posts: 12

Joined: November 29, 2004

Location: United States

Posted: September 08, 2005 at 9:09 PM / IP Logged

thanks

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

1997 gmc jimmy

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.