2007 Honda Accord Alarm/Remote Start Wiring

Home / the12volt's Install Bay / Vehicle Wiring Information & File Requests / 2007 Honda Accord Alarm/Remote Start Wiring (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

mecpman

Member - Posts: 2

Joined: November 29, 2006

Location: Canada

Posted: November 30, 2006 at 8:37 AM / IP Logged

hey just wondering if anyone knows if the 07 accord is different from the 05, 06, and if so does anyone have the info directechs doesnt seem to have it up yet

KarTuneMan

Platinum - Posts: 7,056

This member has made a donation to the12volt.com. Click here for more info.

This member consistently provides reliable information

Joined: December 14, 2004

Location: Isle Of Man

Posted: November 30, 2006 at 3:13 PM / IP Logged

Wire/Function

Colour

Location/Description

Polarity

PASSIVE ANTI-THEFT

YES

TRANSPONDER

SEE NOTES

12 VOLTS

White

Ignition switch harness

IGNITION

BLACK / YELLOW

Ignition switch harness

ACCESSORY

BLACK/ red

Ignition switch harness

STARTER

BLACK/ white

Ignition switch harness

KEY SENSE

RED / white

Ignition switch harness

TACH SIGNAL

SEE NOTES

Locate the PCM at the front floor of the center console. Remove the plastic cover on the passenger side to expose the connectors. On the 4 cylinder use Blue/red at pin 25 of the white plug. On the V6 use Blue at at pin 23 of the gray plug.

FUEL INJECTOR

Opposite of BLACK / YELLOW

At any injector on engine

LOCK

Pink/black

In green plug on left side of fusepanel

These wires are mastered from the passenger side switch, test wires using that switch.

UNLOCK

Pink/blue

In green plug on left side of fusepanel

These wires are mastered from the passenger side switch, test wires using that switch.

DOORPIN

GREEN/ red

In green connector behind fusepanel

HOODPIN

Yellow/red

At hoodlatch in engine compartment

TRUNK PIN

Blue/black

In driver's kickpanel (harness to rear)

TRUNK RELEASE

YELLOW /GREEN

In driver's kickpanel (harness to rear)

FACTORY ARM

WHITE/ red

At driver's door controller

This module is part of the switch assembly inside the driver's door. You must run 2 wires through the door jamb boot.

FACTORY DISARM

White

At driver's door controller

This module is part of the switch assembly inside the driver's door. You must run 2 wires through the door jamb boot.

BRAKESWITCH

WHITE/ black

At switch above brake pedal

PARKLIGHTS

RED / black

At top of fusebox or DKP

HORN

GREEN/ YELLOW

At steering column

VSS WIRE

Blue/white

PCM in front of center console

In white plug on 4cyl. And in gray plug on V6.

TRANSPONDER IGNITION

BLACK / YELLOW

At 7-pin plug on Ignition switch assembly

TRANSPONDER DATA 1

RED / blue

Pin-2 at 7-Pin connector

DATA

TRANSPONDER GROUND

BROWN / yellow

Pin-1 at 7-Pin connector

mecpman

Member - Posts: 2

Joined: November 29, 2006

Location: Canada

Posted: November 30, 2006 at 4:50 PM / IP Logged

thanks for the info to bad i didnt check it untill i was done with the car I just went as if it was a 2006 and its basicly the same car but i can tell ya all the info was correct that ya gave me

cheap installs aren't good and good installs aren't cheap

a1tech

Member - Posts: 3

Joined: November 23, 2005

Location: United States

Posted: January 29, 2007 at 7:16 PM / IP Logged

They must be the same information if the body style is the same.

Good at repair car and remote car starter

a1tech

Member - Posts: 3

Joined: November 23, 2005

Location: United States

Posted: January 29, 2007 at 7:26 PM / IP Logged

mecpman wrote:

hey just wondering if anyone knows if the 07 accord is different from the 05, 06, and if so does anyone have the info directechs doesnt seem to have it up yet

I Think it must be the same information if the body style is exactly the same but you always double check all the wire before you connect the wire, always use digital meter to check it . Never use Test light. Test light may cause damage the car's sensitive electronic.

Good at repair car and remote car starter

green6767

Copper - Posts: 209

Joined: October 28, 2005

Location: United States

Posted: January 29, 2007 at 11:51 PM / IP Logged

been using a test light now for 7 years installing, never use a DMM unless finding resistor values. NEVER had a problem occur because of my test light.

Shaun, we are the same height, that is neat!

12V Installation Technician for Honda, Dodge, Chrysler, Toyota and Jeep.

queva1

Member - Posts: 1

Joined: March 04, 2007

Location: United States

Posted: March 04, 2007 at 10:08 AM / IP Logged

not sure if anyone knows this or if it even exists but i am looking for a amp turn on wire from my factory radio in my 07 accord se (its the 6 disc changer)

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

2007 Honda Accord Alarm/Remote Start Wiring

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.