the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

2006 subaru sti vss


Post ReplyPost New Topic
< Prev Topic Next Topic >
docdc75 
Member - Posts: 3
Member spacespace
Joined: June 06, 2003
Location: New York, United States
Posted: April 11, 2006 at 5:59 PM / IP Logged  

i'm getting ready to install a pioneer avic d1 into a 2006 subaru sti. does anybody know where i can get the vehicle speed sensor pulse from? and how to comfirm it the right wire?

smc0922 
Member - Posts: 14
Member spacespace
Joined: December 03, 2003
Location: United States
Posted: April 24, 2006 at 7:01 PM / IP Logged  

you are looking for green with yellow stripe or green with black stripe. wire should rest at 3-5VAC when parked and go up with speed. All you have to do is drive it about 30 feet and the reading should go up and down as you accelerate and decelerate. connect red wire of your voltmeter to this wire and the black wire to chassis ground.

On the non-turbo models the vss is in pin 12 of the 35 pin plug. On the turbo models the vss is in pin 13 of the 35 pin plug. On the STi models the vss is in pin 26 of the 35 pin plug.

The vss wire is also found behind the instrument cluster.

However, with the D1 you do not NEED to hook up VSS. if you dont, it will get your speed through GPS, but will not know your speed if you are in a tunnel or have no GPS signal for any other reason. smc0922@hotmail.com if you have any other ?'s.

-Shawn

MECP First Class Installer Certified

smc0922 
Member - Posts: 14
Member spacespace
Joined: December 03, 2003
Location: United States
Posted: April 24, 2006 at 7:11 PM / IP Logged  
I forgot to add the wire will be found at the ECM which is where the passenger's feet would be, under the mat. its a silver box about 7" square under a protective metal plate. 10mm nuts secure the plate to the car.
Longshot421 
Member - Posts: 7
Member spacespace
Joined: November 12, 2004
Location: Canada
Posted: May 21, 2006 at 11:35 AM / IP Logged  

I'm installing a Pioneer AVIC N1 right at this second in a 2005 STi - I've researched a fair bit, and I'm 99% that the wire I want to tap into for the speed sensor is the 2nd pin of the right of the 3 connectors that connect to the combination meter (speedo, tach etc.) - C2 of connector i10 according to my wiring diagram - this is for a 2005 STi. Maybe not exactly the same as your installation, but any chance you can confirm this is the correct wire? I can't figure out a way to check before I tap into it, and basically I'm scared of screwing up the speedo! Any info much appreciated. 2006 subaru sti vss -- posted image.

I posted this same question on a Subaru board as well.  I'm basing my interpretation of this being the correct wire on the "troubleshooting" steps for problems with the speedo - and it gives the same info that if everything is OK, the reading will go from 0 - 5V depending on speed.

audiobahn77 
Member - Posts: 7
Member spacespace
Joined: December 22, 2004
Location: United States
Posted: May 29, 2006 at 6:35 AM / IP Logged  

smc0922 wrote:
I forgot to add the wire will be found at the ECM which is where the passenger's feet would be, under the mat. its a silver box about 7" square under a protective metal plate. 10mm nuts secure the plate to the car.

Do you know if this is the same for an 04 STi?  I'll be installing my friend's Eclipse AVN 5435 next weekend.  I just hooked mine up in my RSX Type-S to a wire on the ECM and would like to do the same on his since it's easy access.  Wire color and pin location for the VSS is much appreciated.  If you happen to know where to hook up the reverse wire as well, that would be great.  I didn't hook mine up on my car, so I'm not sure about his either.  Thanks again for any info.

somebody help me please
smc0922 
Member - Posts: 14
Member spacespace
Joined: December 03, 2003
Location: United States
Posted: June 01, 2006 at 7:50 AM / IP Logged  

04-06 share the same location for the ecm. that goes for imprezas, wrx's, and STi's.

-Shawn
AIM: Creegman9695
smc0922 
Member - Posts: 14
Member spacespace
Joined: December 03, 2003
Location: United States
Posted: June 01, 2006 at 7:54 AM / IP Logged  
audiobahn77 wrote:

smc0922 wrote:
I forgot to add the wire will be found at the ECM which is where the passenger's feet would be, under the mat. its a silver box about 7" square under a protective metal plate. 10mm nuts secure the plate to the car.

Do you know if this is the same for an 04 STi?  I'll be installing my friend's Eclipse AVN 5435 next weekend.  I just hooked mine up in my RSX Type-S to a wire on the ECM and would like to do the same on his since it's easy access.  Wire color and pin location for the VSS is much appreciated.  If you happen to know where to hook up the reverse wire as well, that would be great.  I didn't hook mine up on my car, so I'm not sure about his either.  Thanks again for any info.

-Shawn
AIM: Creegman9695

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Wednesday, April 24, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer