Door locks

Printed From: the12volt.com
Forum Name: General Discussion
Forum Discription: General Mobile Electronics Questions and Answers
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=1024
Printed Date: May 12, 2025 at 8:08 PM

Topic: Door locks

Posted By: Ron_toolman
Subject: Door locks
Date Posted: May 29, 2002 at 8:29 PM

Hello,

I just installed a Bulldog Remote starter in a 88Tempo and having problems
getting the locks to work, this is a type C door lock system which requires
extra relay's. When I install then according to the diagram it pop's the fuse.

Is there an easy way to insatll these relay's ?.....seems that I may be hooking them up
to the wrong end of the wires I've cut, they're two pink wires one with a yellow stripe (unlock) and the other
is pink/green (lock), located at the drivers kick panel. Lock = # 86 pulse from remote, # 30 to one side and # 87a
to the other side, # 87 and 85 are connected to 12 volts. The asme for the unlock relay but with a different wire connected to
the # 86 pin on the relay, however this keeps poping the fuse.

Any help would be appreciated.

Thanks Ron.

Replies:

Posted By: trusdamanr
Date Posted: May 30, 2002 at 6:34 PM

hey ron the system should come with a 5 pin wire harness module and there should be no need for the relays...... with the 5 pin harness it should look like this.........

GREEN/ black----unlock from the motor

GREEN / WHITE----unlock from the switch cut the pink / YELLOW in between

blue/black---lock from the motor

blue/white---lock from the switch cut the pink/lt.green in between

RED / black gets fused at 12 volts constant

i hope that helps good luck

Posted By: Ron_toolman
Date Posted: May 31, 2002 at 1:10 AM

Quote: Originally posted by trusdamanr on May 30, 2002
hey ron the system should come with a 5 pin wire harness module and there should be no need for the relays...... with the 5 pin harness it should look like   this.........
GREEN/ black----unlock    from the motor
GREEN / WHITE----unlock   from the switch      cut the pink / YELLOW in between
blue/black---lock from the motor
blue/white---lock   from the switch              cut the pink/lt.green in between
RED / black gets fused at 12 volts constant
i hope that helps good luck

Posted By: Ron_toolman
Date Posted: May 31, 2002 at 1:13 AM

Thanks, trusdaman

I just revered the wires and the door looks work fine, I had the polarity wrong
but they wok great now, Thanks.