vacuum diagram

Printed From: the12volt.com
Forum Name: General Discussion
Forum Discription: General Mobile Electronics Questions and Answers
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=103933
Printed Date: July 06, 2025 at 11:48 PM

Topic: vacuum diagram

Posted By: tylernye
Subject: vacuum diagram
Date Posted: April 12, 2008 at 6:36 PM

I have a 2004 Ford Explorer with the 4.0 V6. I am trying to get ahold of a vacuum diagram. I broke a vacuum line coming of the intake and I have no clue where it is suposed to attach so I need to get ahold of a diagram so I can figure out where it goes. Thanks.

Replies:

Posted By: KarTuneMan
Date Posted: April 13, 2008 at 12:22 AM

So you have a vacuum line hanging there not connected to a thing right?

And so given that you have a terrible vacuum leak right? The rig runs crappy

The line is only "so long" you cannot simply see how far it will go and look at all the potential places.

I would get a can of carb cleaner and have someone in the rig on the gas. Slowly spray the cleaner in the areas that you hose "could reach"

When you idol goes nuts..... take a look.

-------------

Posted By: tylernye
Date Posted: April 13, 2008 at 7:51 AM

It ran really bad with it not pluged up so I just plugged it up and it runs fine its just now I have my check engine light on. Well I found out it is for the Evaporative system. So I order a new hose through the dealer and I will get them to show me where it goes.

Print Page | Close Window