I'm adding an aftermarket remote starter to factory keyless entry, I've figured out most of it but I can't find the factory keyless entry box to tap into the lock and unlock, (to activate the starter you press lock-unlock-lock within 10 seconds). The book says I'll need to install diodes to keep from activating the starter with the interior switches. So if anyone knows where i can get a wiring diagram for this i would be very grateful. This is in a 2001 Pontiac Grand Am 2 Door.
-------------
Good Luck, Michael M
| ITEM | WIRE COLOR |POL| WIRE LOCATION |
| 12V|red |+ |ignition harness *1 |
| STARTER|yellow |+ |ignition harness *1 |
| IGNITION|pink |+ |ignition harness *1 |
| SECOND IGNITION|dk. green |+ |ignition harness *1 |
| ACCESSORY|orange |+ |ignition harness *1 |
| SECOND ACCESSORY|brown |+ |ignition harness *1 |
| POWER LOCK|white |- |drivers kick panel in |
| POWER UNLOCK|same wire |*2 |a black plug |
| LOCK MOTOR|gray | |drivers kick panel |
| UNLOCK MOTOR|tan | |drivers kick panel |
| DISARM DEFEAT|tan | |passenger kick panel |
| PARKING LIGHTS +|brown | |passenger kick or column |
| PARKING LIGHTS -| | | |
| HEADLIGHTS|dk. blue & pink |*3 |steering column |
| DOOR TRIGGER|*4 |- |*4 |
| DOME SUPERVISION|white |- |dash light or column |
| TRUNK/HATCH PIN|ORANGE / black |- |trunk light |
|TRNK/HTCH RELEASE|BLACK/ white |+ |drivers kick panel |
| TACHOMETER|white or PURPLE / wht | |ignition coil or ECM *5 |
| SPEED SENSE|dk.GREEN / WHITE | |ECM *5 |
| BRAKE WIRE|lt. blue |+ |at the switch |
| HORN TRIGGER|black |- |steering column |
| WIPERS|dk. grn & purple |+ |steering column |
| LF WINDOW UP/DN|dk. blue - gray |A |drivers door switch |
| RF WINDOW UP/DN|lt. blue - tan |A |drivers door switch or kick |
| LR WINDOW UP/DN|dk. green - pur/wht |A |drivers door switch or kick |
| RR WINDOW UP/DN|lt. green - purple |A |drivers door switch or kick |
| SUN RF OPN/CLOSE|blue - green |A |sunroof motor |
| SUN ROOF LIMIT| | | |
| RADIO 12V|orange |+ |at radio |
| RADIO GROUND| | | |
| RADIO SWITCH|yellow |+ |at radio |
| RADIO ILLUMINATE| | | |
| POWER ANTENNA|dk. green | |at radio |
| LF SPEAKER|tan - gray | |at radio or LF speaker |
| RF SPEAKER|lt. grn - dk. grn | |at radio or RF speaker |
| LR SPEAKER|brown - yellow | |at radio or LR speaker |
| RR SPEAKER|dk. blu - lt. blu | |at radio or RR speaker |
Notes:
NOTE: This vehicle has the passlock II immobilizer system that, when adding a remote start, must be interfaced with. Use DEI part 555t or 555L. *1 Remove the radio, without unplugging it, to access the ignition harness. *2 Lock requires a negative trigger, and unlock requires a negative trigger through a 1,500 ohm resistor. Must use relays. Must close doors to lock with a single pulse. *3 Requires a high current ground. Use a relay. *4 The lt. GREEN/ black is located in the drivers kick and catches only the drivers door. The lt. blue is located in the harness coming from the drivers running board going under the drivers seat and it catches all other doors. Use both door trigger wires and diode isolate each. On the 2 door the lt.blue is in the passenger kick. *5 The ECM is located under the left side of the dash to the left of the column.
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Thank you for all the info. Where can I find the DEI part # 555t or 555L? I really appreciate all of this.
-------------
Good Luck, Michael M