Window module

hey Tman! pink may not be needed(it is probably to break a sensor input to an alarm if the windows set it off). YOu will have to find the up wire for the drivers window and cut this in half,once cut you will wire the the green on the motor side and the white on the switch side.You will do the same for the passenger up wire for the blue and brown wires.

Orange wire will need a diode and go to the same wire that arms the starter kill usually orange as well!

REd will get a constant power from a high current source the 12 volts constant to the window switch can supply this or direct to battery.

And ground well that goes to a clean piece of metal in the car on the body.

What if I wanted to use it for my remote control to control the window going up....... Is that possiblie

the way i said it the windows will go up on arming of alarm if you want to use an additional button to roll up u can use an auxilary output from the alarm(if it has a usable one)that way you can roll them up manually.

So I have to cut the wires in half or I spit pieace of the wire and connected it to the wire... and the didoe goes on how, the cathoe or thee annode goes to the window module thatnks

if using an aux channel no diode is needed, only diode if using orange wire from alarm-- band faces the alarm.

you only cut the window up wires in hal only them!!! the otehrs all get just spliced in.

when do you want the windows to roll up upon arming?? Or do you want to roll them up yourself with remote?

I want them to go up when I hit the button on the control

the lock button?or the aux button??

The aux button

ok then use the wire from the alarm that controls the aux button,and connect that to the orange wire on the window module no diode needed.

Ok Thanks, One more thing what is the propose of the pink wire says to accessory item?

you may have to program the alarm if that aux channel has options !Im not familiar with the alarm u have you will have to look in the install book. it may have a latched output,or it may have to be held down for the windows to go up ,there is many ways this wire can work .

It is probably used to break a sensor input from the alarm(shock sensor usually) so that when window module rolls windows up it dont set off alarm. Usually not needed,you will have to see when installed if you need it.

You wont burn your alarm if you folow directions and be carefull thats it. Dont use the aux channel for anything else but the window module. This is the only physical connection to the alarm the rest or vehicle connections. And dont power up the window module off the ignition switch in the car-- instead use the battery if posible. make sure you have a good ground and make your window connections solid this will be easy .

and make sure your aux channel is a ground that can supply 500 ma if not you may want to add a relay usually they can but it is always good to check in manual.