Print Page | Close Window

2003 ford p/u

Printed From: the12volt.com
Forum Name: General Discussion
Forum Discription: General Mobile Electronics Questions and Answers
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=27749
Printed Date: August 03, 2025 at 1:09 PM


Topic: 2003 ford p/u

Posted By: short
Subject: 2003 ford p/u
Date Posted: March 04, 2004 at 8:14 PM

looking for wiring diagram for ford 2003 250 p/u



Replies:

Posted By: mobile1
Date Posted: March 04, 2004 at 8:30 PM
12volts
yellow & lt. GREEN/ purple
+
ignition harness

Startergreen + ignition harness
Second StarterN/A
IgnitionRED / lt. green or WHITE/ yellow + ignition harness
Second IgnitionN/A
Third IgnitionN/A
Accessorygray / YELLOW & RED / black + ignition harness
Second Accessoryblue/lt. green + ignition harness
Keysense
Power Lock
Power Unlock
Lock Motorpink/black 5wiVSM
Unlock MotorRED / orange 5wiVSM
Parking Lights+brown + headlight switch
Parking Lights-N/A
Hazardssame as turn signals
Turn Signal(L)lt grn/wht (F), lt grn/org (R) + steering column
Turn Signal(R)wht/lt blu (F), org/lt blu (R) + steering column
Reverse LightBLACK/ pink + fuse box
Door TriggerBLACK/ lt. blue + either kick panel
Dome Supervisionuse door trigger
Trunk/Hatch PinN/A
Hood PinN/A
Trunk/Hatch ReleaseN/A
Power Sliding DoorN/A
Factory Alarm Arm
Factory Alarm Disarm
Disarm No Unlock
TachometerNOT RED / lt. green ac any ignition coil
Wait to startsee DirectFax document 1091
Brake Wirelt. green + brake pedal switch
Parking Brakelt. GREEN/ red - parking brake switch
Horn Triggerblue - steering column or VSM
Without keyless entry use pink / YELLOW for lock and pink/lt. green for unlock. They are 5 wire reverse polarity mastered from the driver switch and found in either kick panel. With keyless entry use WHITE/ red for lock and BLACK/ white for unlock. They are negative trigger and found at the VSM. The VSM (Vehicle Security Module) is to the right of the accelerator pedal above the transmission hump below the radio. Not accessible from radio opening.



Posted By: short
Date Posted: March 04, 2004 at 8:45 PM

thanks

i would like to know how to turn on dome light without using door tigger if possible heres the reason

alarm set, remote start car, if the car times out before i get to it the car it shuts off and the dome light comes on and sets the alarm off i figured how to get by that problem with a time delay relay but i also would like my dome light to come on when i unlock the door




Posted By: NowYaKnow
Date Posted: March 05, 2004 at 5:54 AM
Most units have a seperate wire for the door trigger and the dome supervision. Just tie your dome supervision wire in after the time delay relay to the BLACK/ blue (+) and you should be good to go.

Mike





Print Page | Close Window