Print Page | Close Window

remote starter w/ keyless entry

Printed From: the12volt.com
Forum Name: General Discussion
Forum Discription: General Mobile Electronics Questions and Answers
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=34933
Printed Date: May 12, 2025 at 5:02 AM


Topic: remote starter w/ keyless entry

Posted By: Windstarh2o
Subject: remote starter w/ keyless entry
Date Posted: July 01, 2004 at 11:26 PM

I have just bought a Commando EZ-2500 for a 97 Ford Windstar,  does anybody have suggestion/tips for installing?  This will be my 1st.



Replies:

Posted By: jfk51502003
Date Posted: July 02, 2004 at 10:26 AM

DIRECTWIRE™ WIRING INFORMATION - FORD / WINDSTAR / 1997 / Remote Start

[PRINT THIS PAGE]

12voltsyellow + ignition harness
Starterwht/pnk or RED / blue + ignition harness
Second Starter
IgnitionRED / green + ignition harness
Second IgnitionBLACK/ green + ignition harness
Third Ignition
Accessorygray / YELLOW + ignition harness
Notes: May be more than one - test to verify which one powers blower and A/C controls.
Second AccessoryBLACK/ pink + ignition harness
Keysense
Power Lockpink / YELLOW - drivers kick panel
Notes: The keyless module is behind center storage compartment.
Power Unlockpink/green - drivers kick panel
Notes: The keyless module is behind center storage compartment.
Lock Motor
Unlock Motor
Parking Lights+WHITE/ black light switch
Notes: One of two, only one is the parking lights.
Parking Lights-
Hazards
Turn Signal(L)
Turn Signal(R)
Reverse Light
Door TriggerBLACK/ blue + kick panel
Dome Supervision
Trunk/Hatch Pincommon with doors
Hood Pinblack - at sw under hood
Trunk/Hatch Release
Power Sliding Door
Factory Alarm Arm
Factory Alarm DisarmGREEN/ purple - either kick panel
Disarm No Unlock
Tachometer AC
Notes: On the 3.0 liter motor the tach wire is yellow/black. On the 3.8 it is dark blue/light green. Follow spark plug wires to coil assembly on both motors.
Wait to start
Brake WireRED / lt. green + brake pedal switch
Parking Brake
Horn TriggerYELLOW /GREEN - ignition harness
Memory Seat 1
Memory Seat 2
Memory Seat 3
posted_image
Immobilizer Bypass Module:Required: NoType: N/APart #: N/A
Notes: N/A


This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.




Posted By: Windstarh2o
Date Posted: July 02, 2004 at 9:47 PM
Thanks for the data.


Print Page | Close Window