Print Page | Close Window

what software to use with vinyl cutter?

Printed From: the12volt.com
Forum Name: General Discussion
Forum Discription: General Mobile Electronics Questions and Answers
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=37043
Printed Date: July 02, 2025 at 11:50 PM


Topic: what software to use with vinyl cutter?

Posted By: crudeau
Subject: what software to use with vinyl cutter?
Date Posted: August 09, 2004 at 9:06 AM

Hey guys,

 Not what section to really put this in, but I just acquired an IoLine Super 88 vinyl machine.  And I am trying to determine what to software to run it with.  I know I can use like Corel draw 8 or illustrator 9 along with some bridge software.  But I am unsure of where to get bridge software.  I would really like to use something for free.  be it freeware or something off kazza or limewire.  I just don't want to shell out a couple hundred bucks until I am sure I want to use the machine and that it is all working.  And i already have a p4 system that is ready to run it, just need some software to dump on it and I am good to go.

Thanks,

Chris




Replies:

Posted By: 01xcab
Date Posted: August 09, 2004 at 6:52 PM
I dont think theres any bridgeware thats freeware.
if you had a Roland you could cut directly from Corel
I have one for sale if interested.
Not too many people using Iolines cant say if thats good or bad.I think theres a co cut version thats under $300.
Check with SummaGraphics whos licensed the Co Cut.


Print Page | Close Window