LCD Digital Voltmeter Mounting

Printed From: the12volt.com
Forum Name: General Discussion
Forum Discription: General Mobile Electronics Questions and Answers
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=37574
Printed Date: November 07, 2025 at 11:14 PM

Topic: LCD Digital Voltmeter Mounting

Posted By: blues
Subject: LCD Digital Voltmeter Mounting
Date Posted: August 17, 2004 at 10:20 AM

I've just bought a digital voltmeter (EM32-1B) from Lascar Electronics, to monitor my battery and alternator voltages (recently burnt out the alternator). I've got it all up and running, and the LCD voltmeter works very well. Problem is, it needs a round hole with a 32.5mm diameter. Does anybody know of a tool to make a tidy round hole without damaging the surroundings ? The meter's chrome bezel will hide about 2mm of imperfection.

Replies:

Posted By: switch_hitter
Date Posted: August 17, 2004 at 1:48 PM

a dremel, and a steady hand

-------------
2 Memphis HPO 12s
1 Memphis 1000D
2 Memphis 8s
1 Memphis MC200
4 Memphis 3way 6 1/2s
1 Memphis MC3004
4 Memphis Tweeters
1 Memphis 3-way electronic crossover
2 Memphis 5 1/4
2 Memphis 4s

Posted By: TonyPTX
Date Posted: September 11, 2004 at 12:43 AM

I would guess that you no doubt are drilling into some piece of plastic trim?

A spade bit for wood would work just fine. Check out your local home improvement store. A 1 1/4 " spade bit should do it.

TOny

Print Page | Close Window