Keyless Entry Commando

Printed From: the12volt.com
Forum Name: General Discussion
Forum Discription: General Mobile Electronics Questions and Answers
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=46560
Printed Date: July 18, 2025 at 5:11 AM

Topic: Keyless Entry Commando

Posted By: 93olds
Subject: Keyless Entry Commando
Date Posted: January 01, 2005 at 11:54 AM

Probably this is way below the level of this group but I would appreciate some charity.

I bought a Commando KE-30 and 3 Relays to make my 1993 Cutlass Supreme keyless (obviously). They are telling me to pry off my door panel to access the wiring for my relays (the 3rd is for the trunk) but I wonder why I can't just tap into the trigger wiring under my dash board where less damage is likely to occur. Also, I wonder why I can't use the 200 ma lock/unlock outputs hard wired onto the KE-30 receiver and bypass the relays all together. Is the voltage insufficient?

Thanks and I really enjoyed reading through this forum. You guys are all great.

-------------
steve

Replies:

Posted By: KarTuneMan
Date Posted: January 01, 2005 at 5:54 PM

12volts	red	+	ignition harness
Starter	yellow	+	ignition harness
Ignition	pink	+	ignition harness
Power Lock	lt. blue	+	either kick
Power Unlock	black	+	either kick
Lock Motor
Unlock Motor
Parking Lights+	brown		headlight switch
Notes: Also found low in the drivers kick panel.
Parking Lights-
Hazards
Turn Signal(L)
Turn Signal(R)
Door Trigger	white	-	headlight switch
Notes: Also found low in the drivers kick panel.
Dome Supervision	use door trigger
Trunk/Hatch Release	black	+	release switch
Power Sliding Door
Factory Alarm Arm
Factory Alarm Disarm
Disarm No Unlock
Horn Trigger	black	-	steering column

-------------

Posted By: KarTuneMan
Date Posted: January 01, 2005 at 6:03 PM

You'll need to wire up a couple of relays to do the locks thgough.

And one for the trunk pop. All of the outputs from your KE30 are negative, you need to convert em to +Pos.

For all 3 relays

pin87 and 86 gets 12volts fused

pin 85 gets your trigger wires from the KE30

pin 30 becomes your posative(+) out put to trigger your locks and trunk pop

-------------