I have installed the Commando Remote Start But have not installed the door locks yet. My truck did not come with keyless entry. I will pick up a coupla relays for the door locks but just had a question or two.
1) The diagrams here call for "5 wire reverse polarity" and the Instruction manual shows a diagram for "5 wire rest at ground" Are these the same?
2) The diagrams here show the lock and unlock wires (pink / YELLOW pink/lt. green) IN EITHER KICK PANNEL. My instruction shows cutting the wire between the switch and lock and installing the relay between. In reality, do I just want to leave these wires intact and just feed them a POS pulse to lock or unlock?
-------------
Chop_Top on the Go...
OK well no replys so I went ahead a cut the darn thing...
All is well and it all works now. The wires in the drivers side kick pannel for the lock are easy to get at once the pannel is removed. Just pull out the little round do hickie in the middle of the pannel then pull the pannel towards the rear of the truck.
Once the pink wires are cut, the ends to the rear of the truck are the locks and the ends coming from front are from the switch.
-------------
Chop_Top on the Go...