Motorcycle remote starter

Printed From: the12volt.com
Forum Name: General Discussion
Forum Discription: General Mobile Electronics Questions and Answers
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=55538
Printed Date: May 12, 2025 at 10:46 AM

Topic: Motorcycle remote starter

Posted By: kewalk12
Subject: Motorcycle remote starter
Date Posted: May 11, 2005 at 12:31 PM

I've searched alot of forms amd noone couls help me. Ok, I installed the alarm according to the instructions Step by Step, everything works great EXCEPT the remote start feature. When I hit the remote start button the bike will crank but not start. Now, if I have the key in the on position which also preps the fuel pump the remote start with start the bike no prob. My question is how do I get the alarm to first tell the ignition switch to go to the "on" position and THEN crank the bike??? Any help would be greatly GREATLY appriciated, I have A Honda CBR 954 rr 3003, and the alarm is a Thor.

Can Some one please help me.

Replies:

Posted By: oonikfraleyoo
Date Posted: May 11, 2005 at 12:52 PM

Sounds like you have more than 1 ignition wire.

-------------
Nik
Jeeputer Progress
[|||||||||||-] 90%
Check it out.

Posted By: Francious70
Date Posted: May 11, 2005 at 5:16 PM

Do you leave the thumb switch on all the time?? You know, the one on the right handgrip. If you don't have it set to "on", you can crank all day, but it ain't gonna start.

Paul

Posted By: NowYaKnow
Date Posted: May 11, 2005 at 5:23 PM

It has an antitheft system similar to the passlock systems we have on cars. There will be a wire off of the ignition switch that has varying voltage. You need to cut that wire and determine the proper resistor value, and then use a relay to wire it in. This will turn the fuel pump on and allow the cycle to start and run.

Mike