motorola monitor pager base

Hi Im trying to wire up a motorola minitor pager base that has a built in relay which activates a 6 pin din output port when the device is activated. From the website below, it says that 2 of the pins have a 2.5 V dc output. I was wondering how I could wire this up to be able to operate a 110V device. I figure some people here might have some ideas. Im thinkin I will need the charger base to activate another relay which in turn activates the device because the built in relay is rated for like 750mA i think. Any advice would help. Thanks.
https://www.batlabs.com/minitor.html

I am Assuming u mean a minitor as in a fire or ambulance pager both of which i have i would say your best bet is getting a power inverter from 12v to 110v  they are fairly cheap and definatly get the job done other that that i cant think of a solution for ya

-------------
89 honda crx 1 15" Power HX2 jblbp1200.1 rockford coaxials 4 channel comin soon

never mind u did type minitor the subject was changed srry

-------------
89 honda crx 1 15" Power HX2 jblbp1200.1 rockford coaxials 4 channel comin soon